Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
Could someone give me a hint with the following problem?
I am using two example projects (ble_app_uart_c, ble_app_hrs) to connect a central and a peripheral.
An...
I have designed some beacons based on nRF52810. The software uses the minimum functionality of the radio to transmit some packets every second and sleep.
In their sleep...
I've just ran into this issue - I was debugging while developing using a J-Link on our own board. I tried setting up UART, set the pin config to
In hindsight not the smartest...
Hey,
I want to build something like a door sensor. So my device should sleep and if the button is pressed it should wake up and send a message to the leader via thread....
I have a device that I would like to add some features to. I took its remote apart and found the chip to be N52832. I bought an Ubertooth One and scanned while pressing buttons...
Hi there,
According to our understanding, on CPU reset the entire core is set to the secure except for non-secure peripherals. Is this understanding correct?
We are trying...
Hi,
I need to evaluate nordic suggested Sample DFU app on BL653 board : https://devzone.nordicsemi.com/guides/nrf-connect-sdk-guides/b/software/posts/ncs-dfu
But as...
Hello,
Would it be possible to conduct enumeration when connecting to devices like PCs, smartphones, and so on?
For example, would it be possible to obtain information...
Hello all!
I am currently developing on the development board nRF52832, SDK16.0 and SD132v7.2.0.
As mentioned in the subject the virtual pages are overwritten by the application...
Hi,
I use Radio Test in NCS. When the mode was selected to Coded PHY (lr500Kbit, lr125Kbit), it was found that the measured duty cycle was significantly different. For example...
Hi Nordic，
I am using nrf52840 custom board. May I ask, can I replace 4.7uf near VDDH and VBUS pins to a larger cap, like 10uF? As far as I can see, these caps are only...
I wrote some code to read the Adafruit PDM Microphone Breakout board sensor output (ST MP34DT01-M microphone) with Zephyr and nRF Connect SDK into the Thingy 91.
I do this...
Hello
Im trying to use my iPhone 13 with your application nRF Connect as a peripheral.
For some reason the moment I make a connection with another device it automatically...
