I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Isn't there an easier way to use the SDK? For example, to use pwm, you need to change nrf_pwm_enable to 1 and nrfx_pwm_enable, nrfx_pwm0_enable, load_mode, step_mode, base_clock...
Hello, I was reading through the OpenThread Commissioning Guide ( https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/nrf/ug_thread_commissioning.html ) Attempting...
Hi
I am interested in the Non-IP Data Delivery support in the nRF9160 module.
1) Is there or is there no support at the moment? If not, is it planned and when will...
Hi,
My program suddenly stop working and I get this error message
This happening when I want to go in Debug Mode (Debug > Go).I cannot start the program anymore.
I...
Hi Nordic Team!
I am working with nRF5340 DK and nRF Connect SDK 1.5.0
I wanted to use Firmware Upgrade (FOTA) feature with the mesh . So, I have started with Bluetooth...
device_get_binding() this function has many parameters ,very Incomprehensible to use, in the nordic samples i use debug step by step to find what port what pin to be used...
Hello,
I am looking at the schematic for the nRF5340 DK and see that there are no external load capacitors for the 32 kHz crystal which has C_L = 9 pF. Therefore, we are...
Hello!
Hardware: nrf52840 IDE: Segger Embedded Studio SDK: nrf5 SDK 17.0.2
I've been having trouble getting IN reports to work on macOS. I based my code off of the generic...
At present, the nrf52840, sdk package is components_V15.2.0, it will restart probabilistically when the USB is connected to the computer for charging. The hardware reset register...
I use nrf52840 and max30003 and SD card that saves my ECG data. I've tried to make a lot of ECG and this one is the best. But I don't know why some ECG PEAKS are positive...
2021 05 18 west update new source mkdir -p ncs west init -m github.com/.../sdk-nrf --mr master ./ncs cd ~/ncs west update west zephyr-export //// ~/ncs/nrf/west.yml
name...
HI
When I use thread networking program, p0.7 pin is not controlled as IO port, but it is used well in other programs. What's the matter?Is this pin occupied by thread networking...
