I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
I'm using the softdevice S310 on nRF51422 and when the softdevice is enable and I erase flash, the device won't go to sleep.
My code implementation is like as below:
...
There is a way to set the initial value of a characteristic. But how do I set the value after this without sending a notify to the master? Is it possible to write the value...
Hello,
i want use the port event to trigger timer 1. I need only one interrupt source and i don't want to use the pin event because of the higher current consumption. Its...
are there any cheap watch platforms that use nordic?
i want to make a kid alarm / potty alarm watch
do not want to develop hardware
would use nordic if i can find...
Hi,
when i m using only Proximity . when I use
- (void) centralManager:(CBCentralManager ) manager didPeripheralSelected:(CBPeripheral*) peripheral;*
this method in ProximityViewController...
Hi,
I'm trying to transfer data received from BLE to SPI. When the handler of my service in BLE is achieved I transfer the data I received to SPI.
I know the max that...
Hi all,
I am using ble mesh code, it has version based. For my application( needs to blink led synchronously in mesh) i don't need version part, so i tried with using if...
As your datasheet, External HFXO's Run current is 250uA, but HFINT case is 60uA.
Despite lager current, why do you use HFXO in reference circuit?
I would like to use HFINT...
using **nrf_drv_saadc.**c and nrf_saadc .c nRF52832 with sd132v2.0
for example.
i init a app_timer to update a adc channel per 10ms.
and manually update the batt volt...
Hi
I'm trying to send adc value from peripheral to central. I'm using nrf51822 with softdevice s130_1.0.0 and SDK v10.0.0 .
I'm getting error 3002 which I figured out...
