Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
I am quite new to Beacon development. I am trying to use the examples of NRF SDK 10.0 on the NRF Beacon. I would like to "install" the application via OTA. I tried...
Hello,
DFU tool (android) is cool but if you have a lot of devices to update it's long. Is there any batch tool that can update all devices that fit (MAC list or SSID filter...
When executing the Bond command on the 8001 and trying to pair it from my laptop (Windows 10) or iPhone (iOS 9), I receive a strange order of events to the command:
...
I'm trying to replicate an Arduino Uno application where we connect a M3Q alcohol sensor into an analog pin and feed the data into the ADC. The specific board I have is made...
Hello,
sd_softdevice_enable falls in hardfault. I have no 32.768 KHz crystal but is set lfclk with NRF_CLOCK_LFCLKSRC_SYNTH_250_PPM.
I'm running my application on a...
HI,ALL,
i want to try to developer with bluetooth develop studio,which developered by BlueSIG.
i now download the BDS and the PLUGIN for the nordic NRF51.
is there...
Hello,
Does the S120 have support to know on which advertising channel it received an advertisment? Or some kind of feedback to know on which channel the S120 device is...
Hi,
Does anyone know the event end point addresses for the following on the nrf52832:
RADIO_EVENTS->ADDRESS
RADIO_EVENTS->READY
RADIO_EVENTS->END
The addresses for...
Hello guys ,
We developed a product that using a nRF51xx chip and now we are preparing for mass production.
The antenna was designed on PCB and for PCB we are using FR4...
There is a minor issue with the app_fifo library included with nRF5_SDK_11.0.0-2.alpha_bc3f6a0. If the app_fifo_write function is called with the parameter p_size set to 0...
Hi
I am planning to use NRF51822. Have not used these parts yet.
I have 4 peripherals and 1 central hub. All communicating in BLE. And central hub will also connect to...
In our project we are using the nrf51822. We planned to connect an external flash for storage purposes. While coding the software I got the advice to give special attention...
Hi,
I use nRF51822.
Can it judge a UID of higher RSSI level by comparing the RSSI of two advertizers with Central mode in nRF51882?
I want to know a UID of advertiser...
