hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
Hi all,
I am trying to send data from nrf52840 to Arduino. I have a simple UART program running on nrf52840 that is supposed to transmit a character to another device(Arduino...
Hi All,
Hope everyone is fine.
I'm using Vs code with nrf Connect sdk v1.9.1 to develope firmware for nrf52833.
Here our device has no display or Keyboard to give input...
I am doing some profiling with the peripheral_uart sample. It works as expected when I send small pieces of data, but when I start running a lot through it I get a crash....
Hi,
I am working on BLE on nRF52833dvk, am able to execute the sample example . I have one of the requirement, that I need to write the unit test cases for Bluetooth for...
Hi
I would like to use power management module with CAF. I got it somehow working and the device is going to poweroff or standby mode and wakes up, if i push some button...
Hi all
I'm developing a BLE application using nRF52832 : SDK 17.xx
My SW is based on the project ble_app_gls as I need to use a PASSKEY
I experience 2 difficulties ...
Hi
I am positing this here - although maybe that is cheeky of me, as the issue I am having is with an Android app, which I want to use to communicate with a Nordic device...
Hi,
1. Can nRF9160 equipment automatically identify the following two networks?
2.CAT-NB1/NB2
3.CAT-M1
4. Automatically identifies the NB network when inserting a...
Hi,
I have a weird issue occuring when trying to connect to my MQTT server.
If i run the code on a NRF9160 DK i can connect perfectly fine to my MQTT server calling...
Hi all,
In the nRF9160 https_Client sample, I was able to connect to the server by provisioning a server-matched root certificate to the nRF9160.
Can I connect to an...
I've been playing around with the v1.9.1\zephyr\samples\boards\nrf\system_off\ example code, as I want to implement something similar in my own code. But I want to be able...
Hi
I would like to change my coded PHY layer 1MBps to 2Mbps.
For that, i just change the params BLE_GAP_PHY_1MBPS to BLE_GAP_PHY_2MBPS in my code.
But now the function...
Hi,
We are battling to get to the advertised low power values as described here:
https://devzone.nordicsemi.com/guides/cellular-iot-guides/b/hardware-design/posts/measuring...
