Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
pstorage_load and pstorage_clear appear to work fine, but whenever I do a pstorage_store the callback function is never called. This happens whether or not the Bluetooth unit...
Our USB keyboard using nrf24lu1p does not work on Mac OS 10.11.
Before Mac OS 10.11, USB keyboard was worked, but on Mac OS 10.11, it does not work.
I think your library...
In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
What will be the best option for a system that requires low latency and high data throughput.
I have a system with a sampling rate of max 1000 sps for eight channels with...
Hello,
I want to use the Bluetooth Low Energy application with nRF52840-Dongle.
As far as I know, I need to burn the dongle with some suitable fw.
1) Where is this...
Hello,
I am using SoftDevice S140 SDK 7.2.0 with IAR environment . Each time I burn a new image I need to clear all my no init parameters. I tried to read the reset reason...
Hi, i do not have CAT-M1 or NB-IoT in my country. I would like to know if there is any solution i could implement to obtain cellular connectivity while using the nRF9160?...
For reference I am using NCS v2.0 and VSCode NCS plugin programming in C++.
I am trying to get the example ESB TX example working from the nordic sample ( link ).
(Notably...
Tagging Ø yving !
Hello everyone and thanks to the Nordic team for a nice day in Stockholm.
Since the single cell tower localisation was very good compared to GPS...
Hello everyone,
I'm using Gateway (serial example) and send packet "Heartbeat Get" to Devices (Light Switch Server Example )to check alive of devices. But when check alive...
What API could be used to send out ZDO Device announce, when router (zr) or end device joins network ?
Is there any sample code could be referenced?
Thanks,
Robert
Hi!
Three or four months ago I create a ble mesh with 6 nrf52840 Dongles. Now I want to reset all Dongles in order to create a new ble mesh with a different functionnality...
I changed seqValues variable of the following function from 0x8000 to 0x0010. But I can't see LED light darkening. How to dim LED lights by nRF52832 PWM?
static void _ledPwmConfig...
Hello,
I just observed some strange/interesting behaviour. On one of our products there is a green LED connected to Pin 3 of GPIO port 0 on the nRF5340. When I connect the...
Hi everyone, I'm developing a program with the NCS 1.8 using NRF52840 and I want to use the SPI, the fact is that I've to connect my device to those pins
And as you can...
I am using s112_nrf52_7.2.0_softdevice with nRF5_ SDK_17.1.0 and Segger Embedded studio for nRF52805.
My application code uses 150 kb Flash(Out 192 kb) . I want to develop...
