[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
Hi Guys,
I have a MCU RTOS project. in Hardware board, builtin Nodic BLE chip over UART,RTOS BLE stack works fine.
We also have a MCU RTOS Emulator based on Qemu,we...
Hello,
I would like to have more info about canceling the pairing request on iPhone (thru the popup that asks if you want to pair with the device which is managed by iOS...
Hello everyone, I'm severely struggling to perform a simple task. I must be missing a very simple answer and, I hope with your help that I resolve the issue.
I am trying...
if the issue can be worked ,how to do that with android source code? the 2 ble pure devices (not android phone) connect with a ble android phone.
please check below, the...
Softdevice Version： 8.0.0
SDK： 9.0.0 IC：
NRF51822 Rev 3
service： NUS ANCS
When the application is not downloaded, the bootloader is working.
After serial bootloader...
I have enabled UART_1 but cant seem to send any data or receive any, I have hooked it up to logic analyser and cant see any trx data coming from the board.
If i set my...
Hi
I am trying to modify the MCUboot image to meet the requirements of the project one of the rquirements is to boot the application directly from the secondary partition...
Hi, my region does not support LTE-M or NB-IoT. I would like to prototype an asset tracker with GNSS only. To my understanding, i will be able to retrieve GNSS location data...
Hi, I recently I have implemented the Time Model for the nRF5 SDK for Mesh and happy to share my implementation here: https://github.com/hashing-cell/BLE_Mesh_Time_model ...
Hi
We have a project where 1 central shall be connected to 1-7 peripherals. The central sends a short start/stop message to the peripheral then the peripheral starts to...
I have enabled advertising fast and slow mode. But changing from fast to slow mode is almost at same time. How to configure for changing advertising mode slowly?
The following...
Hello,
I am using the 9160 to send MQTT messages which are received on AWS. I am provisioning the devices by creating a thing on AWS, getting the certificates, and loading...
I have a problem that my nRF52840 Central cannot discover one of the my nRF52840 Peripheral sensor services. With the phone I have no problem. Also other services are detected...
Hi team,
I am using NRF52833 DK with PCA10100 on it and s140 soft device version..
While I am merging the ble_app_uart example with ble_app_multiperipheral example, the...
Hi, I'm currently developing an automatic connection BLE system.
I'm using nRF52840 DK with nRF Connect SDK and S140 SoftDevice.
In fact, there exist already other...
Hi Nordic,
I would like to understand the philosophy behind the nRF9160 DK acting as a debugger. I recover my thinky:91 connecting the 10 pin flat cable from thingy:91...
I was using nrfjprog successfully about a year ago before this evaluation was suspended. When I now try it fails.
```
nrfjprog --log --program build/zephyr/merged.hex...
Hello,
I'm trying to writte a sensordriver for the nuvoton NAU7802 ADC in Zephyr using the drivers/sensor API. Here are the most important (I believe) parts of my code:...
