This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
pstorage_load and pstorage_clear appear to work fine, but whenever I do a pstorage_store the callback function is never called. This happens whether or not the Bluetooth unit...
hi...
i am using nrf52382 segger 15.2 version , i am facing issues i couldn't able to send the data ,here i am advertising using condition if my condition satisfied start...
Hello,
I use SDK15.2, SES4.12 and custom board with nRF52840.
I have a strip of ws2812b LED's connected to my device. I've made a simple RGB animation, each frame of which...
Hi,
I've been testing the sample code at_clent with Verizon wireless. I can send AT command to the DK via nRF Connect "LTE Link Monitor".
Q1. run AT%XCBAND=? to print...
Hi ,
I found nRF24LU1+ build in AES co-processor, but I cannot found the processing speed (the time for finish one AES processing) on datasheet.
Because my customer...
Hi,
I know this is a stupid question, but I couldn't find any answer in the forum or anywhere, and it is getting annoying :)
I'm using SEGGER Embedded Studio for ARM ...
Hello All,
I am currently working with two boards of PCA10040
One of them is v1.1.1 and the other one is v1.2.4
My code must connect with other nrf52 boards to exchange...
I am using nRF51422 with the SDK 11. I am using the proximity application primarily for the ADC Battery Level Service. I would like to have the device advertise indefinitely...
Hi.
I am working with an nRF52840. How should I call Softdevice API functions from my app?
and more precisely this GAP function:
uint32_t
sd_ble_gap_tx_power_set...
Hi,
I would like to access to the code of a commercial device that contain n51822 and another device with n52832.
Could someone tell me if that is possible or not (Both...
I am using the SDK 11 and nRF51422 device. I have built and run the ble_app_proximity application, however, it does not appear that the device is advertising. I am using the...
Hello,
I got a nRF8001 Development Kit. On a peace op paper inside it says: "Follow the steps on My Page and add a product key. ...Download and read the user Guide"
I...
Hi,
I download the nRF9160 SDK month ago.
It can pass the SES build.
I saw there is new Simple MQTT example on github.
I download the new SDK from github today.
...
Hello,
I'm using a module with nrf52840 and I'm testing a vendor model implementation. The software interactive pyaci configure and send packet to device without problems...
