Hello Team,
Could you please share some sample application or procedure to handle power modes (Sleep, Deep Sleep, etc) of the nrf9160.
Please let me know.
Regards, ...
Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
Hi,
I followed the tutorial in the DevAcademy nRF Connect SDK Fundamentals where we try to establish an I2C communication. I managed to compile it, but the i2c_write_dt...
Hi,
I am using bl653_dvk board and ibeacon in zephyr
1. As of clearly i can communicate and update data periodically by using zephyr ibeacon
2. Comming to my issue i...
Hi i was wondering how could i send, with a coap response, one's device network name and a, for exaple a temperature value, like this:
<device's network name>: <temperature...
Hi,
I'm using SEGGER Embedded Studio to write code that writes BLE characteristics to flash storage (via FDS) when they're changed. When the device starts up after a reset...
Hiya,
I was recently looking into using libuarte (alongside SD related functionality) and while trying to pump as much data as I could over UART noticed some missing bytes...
Hi,
I am using the nRF9160 with a multi IMSI SIM card in the US. The SIM supports the 3 major cell operators in the US. I have a case where the modem registers to a network...
Hi:
May I ask 2 questions about LLPM's protocol.
1. BLE have 3types : 1M 、2M and BLE coded 。 During the application of LLPM in nRF52xxx chip, which type do you use, and...
Hi everyone,
I use the UARTE to receive data, and I want to clear rx buffer every time, because If not when the buffer will be full , the next data I received will be split...
Hello,
I'm in the process of migrating from arduino to SES IDE(For more practicality and functionality now what I'm trying to achieve is saving time by not having to rewrite...
Does the s140 softdevice use heap? If not, is it safe to set __HEAP_SIZE makefile variable to 0 ?
(as it is stated for s132 softdevice in the following post softdevice...
Hi,
I am currently using the nRf52832 for ble development in our project. Currently we are facing issues with the service changed characteristic in between firmware upgrades...
Hello,
I am working with a sensor that requires i2c(twim) communication with the sensor and was wondering if there are any good i2c examples using the zephyr drivers to...
Hello,
I am new to the nordic family. I am trying to bring up the UART1 in 9160 DK but it's not working. The same code works for UART0 appropriately.
And the code...