Hello Team,
Could you please share some sample application or procedure to handle power modes (Sleep, Deep Sleep, etc) of the nrf9160.
Please let me know.
Regards, ...
Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
Hi,
As seen in datasheet nRF52840 has one antenna Pin. We can connect either PCB Antenna or Ceramic or External Antenna. Is there a way I can use any RF switch to toggle...
Hi, I have been experimenting with an NRF5340dk for the past few days around the application of emulating a Mass USB storage device when connected to a PC.
I came across...
The error^^
Following the steps outline in this article to add MCUboot: https://devzone.nordicsemi.com/guides/nrf-connect-sdk-guides/b/software/posts/ncs-dfu
start with...
Hi,
I am building an app which has 7 central links and 1 peripheral link with PCA10040 DK board and S132. The central links look OK. But when I use the peripheral connection...
Hi There,
Environment Description:
1. nRF Connect for VS Code v2023.1.44.
1. NCS Version v2.0.0.
2. Zephyr v3.0.99-ncs1.
3. MCUBoot v 1.9.99
4. NRF52840.
5....
I'm working on a project that I need to write a file in the flash memory, but when I calling the function to open file (fs_open), the microcontroller crashes completely and...
Hello! Apologies if my ticket subject is a little unclear or if the terminology isn't correct. I'm currently trying to investigate an issue that causes my device to get stuck...
Hi, devzone,
I'm currently trying to flash the nrf52840 dongle from a custom IMX6-Ull board where it is attached and I'm also able to communicate and run the application...
Hi!
I am currently working on a project that involves taking a command sent over UART and broadcasting the data sent in that command to a number of BLE Mesh devices. I currently...
Hi,
I can't implement advertising on CODED PHY with primary advertising use PHY 1M and secondary advertising use CODED PHY on NCS2.1.1. Then I read the description about...
I am looking as using pwm and timers and trying to get them to use the HFXO rather then the internal RC as I need the higher accuracy. I know how to start it using the below...
Hi,
we found out after upgrading to SDK2.2.0 that sdc_hci_cmd_vs_zephyr_write_bd_addr does not accept a public bluetooth address anymore, this worked fine with SDK 2.1.0...