Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
I have two custom PCBs, each of which has a microcontroller and an nrf24L01+. Everything related to the transceiver in the designs are complete duplicates (with the exception...
Hello,
I've built a small BLE-device based on the nrf8001.
With my Iphone I can discover this device and I am able to connect to it and listen to notifications of the...
Our pcb is used for gps location data. We have a nrf24L01 nordic chip as the micro process or between the gps module and wireless module (2G). Our engineer needs to capture...
Hey folks,
I'm trying to modify the SPI Master loop back example into a 4 line SPI Master_Slave program. Whenever I change the Tx_Buffer_lenght from 10 to lsome other numbers...
Hello, I have a problem I have been unable to solve for more than a week. I have searched as best I know how to no avail.
Windows 10, Segger Studio, Mbed studio, nRF Connect...
Hello there,
I've been trying to run some basic code on nRF5340 PDK. I downloaded and installed the following:
nRF Connect application v3.6.1
nRF Connect SDK v1.3...
Hi, I have developed custom board on nRF52840 based on Thread and Zigbee SDK 14.1.0.
I wants to use zb_zcl_ias_zone_set_status function to send a report of the changed zone...
I have a problem when using JLinkExe + JLinkRTTClient . My operating system is Ubuntu 18.04, and I compile the project using cmake and gcc (using great helper scripts from...
Hi all,
We have a custom board based on nRF52840, and we are using the nrf52840 DK to program our board(For programming the chip, connection from DK to our board is made...
Hi.
Device : nRF52820
SDK 17.0.2 ( Softdevice 7.2.0)
I initialized the clock as below to use USB.
And before changing to sleep mode, the clock was stopped to...
Hi，
So I was using nRF52810 with epoxy or resin coated，but actually the signal quality did not match my needs, the signal faded about 20dB compared to the device which not...
Dear Members,
I manage to display data from GSC10 sensor ? but after few minutes in idle, it can not receive a data anymore,
How can I restart again ?
Is it related...
I am using the nrf52-ble-app-uart-c-multilink-master getting data from 4 UART peripherals that are connected. Once one of the clients disconnects, I am getting an error as...
I have a custom board using nRF52840. Some boards return success from sd_ble_gap_adv_start but no advertisement is seen in nRF Connect running on a Google Pixel 4 phone. Of...
