Hey folks,
I'm trying to modify the SPI Master loop back example into a 4 line SPI Master_Slave program. Whenever I change the Tx_Buffer_lenght from 10 to lsome other numbers...
Hi.
I am using S130 softdevice version.
Basically, I am using NUS Service and make a my own NUS central service as NUS_C.
It is correctly work at normal state.
When...
Hi All,
Please Reviwe for a attached circuit file(Chip ANT of nRF51822.pdf).
I also attach a datasheet of chip antenna applied for that circuit(SDBTPTR3015 Data Sheet...
to me it made sense that EN_AA settings are controlling the receiving pipes if an ACK has to be sent back upon receiving a valid packet.
then i thought that the settings...
I am using BLE_Gateway example defined in nRF51-ble-bcast-mesh to create an rbc_mesh over 2 nRF51422 devices . For now, I am just testing it out on 2 nRF51422; I will set...
Hello,
I see when you import an example from the pack installer ( for example pwm, ble, timer examples ) it arrives with the misc controls --c99 on by default , so I cannot...
Hi Sir
Is it possible write a hex file to external QSPI flash by nrfjprog ? if yes, please tell me what's the command ? Thank you.
ps, the hex file is data, not firmware...
We are using nRF52840 SDK 15.0 with Segger embedded studio. We have referred ble_app_proximity example only for read battery level using ADC. Now in our application used SAADC...
Hi, I m using nrf 51822 development board. I want to implement timer in input mode to detect falling edge of the pulse.. It should give intrude when any falling edge is detected...
Hello
I am a big fan of Zephyr OS, and have developed several commercial products with it (on other NRF chips)
I would like to know if the nrf9160 is to be supported...
Hello, I would like some guidance on how to create a standalone executable for nrfutil (like nrfutil.exe on Windows) in order to update my hardware through OSX. Very newbie...
Hi,
I need some clarification about how to create multiple Timer functions?
my application is to
1. read the VDD supply for every 10 sec
2. after BLE connected to...
Hi,
I'm trying to run fatfs example in sdk. I only changed the spi pin numbers. What is wrong with that?
Here is RTT screen.
My schematic is; CS-------------P0.08...
Hi,
I know I have been asking quite a lot of questions lately, so I hope Im not too annoying ;)
my application currently runs very stable (no hard faults or whatsoever...
Hi,
I know I have been asking quite a lot of questions lately, so I hope Im not too annoying ;)
my application currently runs very stable (no hard faults or whatsoever...
I try to active the serial example in the nordic folder nRF5_SDK_15.2.0_9412b96. When using RX_PIN_NUMBER 8, TX_PIN_NUMBER 6, CTS_PIN_NUMBER 7, RTS_PIN_NUMBER 5, HWFC true...
Hi all,
I am learning about the combination between Bluetooth mesh and NFC. I would like to realize a simple exercise below.
Assuming that I have a mesh network with 4...
Hi,
I am using NRF 52840 DK ,rev.1.0.0(2018.36) and nrf52840 dongle(1018.34.For development using ubuntu 14 and windows machines and segger IDE.
Board details:
NRF 52840...
