Hello,
I see when you import an example from the pack installer ( for example pwm, ble, timer examples ) it arrives with the misc controls --c99 on by default , so I cannot...
Hi,
We're looking for a low-latency 2.4GHz solution (not BLE) and the nRF51822 is oft-quoted as providing low latency, but what are the typical ms figures we could achieve...
Hello all,
in my previous question (Switch between applications (multiple services.h)) I got the advice to merge my two services into one service, including a HID over...
I am trying to create an nRF8001 based application that will broadcast battery levels (pipes broadcast, set), and give out temperature data (pipe indicate - TX_ACK) to connected...
Hi,
I'm using redbearlab's nrf51822 board. It is a arduino compatible board and hence it is using 0,1 (mapped to 9 and 11 for nrf51822). How do I make printf print to this...
An external PA/LNA is used to extend range of nRF51822, and S110 is used for BLE, How to switch between PA and LNA? and how to disable PA/LNA when there isn't transceiving...
I am new to Arm and Nordic devices and I am trying to port the Thingy52 firmware to SES so we can add some additional sensors.
I have got the Thingy52 firmware to compile...
Hi Nordic Community,
I follow the below link to create an openthread border router. I successfully send sensor data on things.io.
https://infocenter.nordicsemi.com/index...
I've implemented the nRF52840 QIAA var5 reference design in hardware and it works well. For L2 (10uH) and L3 (15nH), in series off the DCC pin B3, could you perhaps recommend...
Hi
I am using nRF9160DK SLM application to evaluate the MQTT AT command function.
Everything is fine if the MQTT message is the string type shown by the doc.
But when...
Hi,
Is there a way to do OTA secure firmware updates with a Windows application?
I've got some users without Android or iOS phones that want to do updates - and they...
Hi!
I am quite new to Bluetooth and Embedded development and I was wandering if there is a course specifically dedicated to developing a Bluetooth application on this chip...
Hi All,
When working on NCS with SEGGER Embedded Studio Nordic Edition (v5.20b), modify prj.conf will not reflect on rebuild solution.
It seems the IDE doesn't update...
Hello Nordic Team,
i've been evaluating the nRF52833 and i have been having a lot of good success. i have been focused on the SAADC block to ensure it meets my performance...
Hi
Since we need use different C1/C2 (15PF/12PF) for 32.768K XL1/XL2
I check "https://devzone.nordicsemi.com/f/nordic-q-a/37448/asymmetric-crystal-load-capacitors" , and...
Hello,
I'm using nrf connect 1.4.0 and nRF9160 dk
I started testing the aws_iot example. It worked fine with my was set up and was able to see the shadow updated.
...
Hello.
I'm using nrf52833 / SDK 17.0.0
I want to find out SAADC sampling time by using logic analyzer.
However, I still don't know what sampling time is.
In this...
Hi
We are working on the secure DFU. The issue is that the NRF52832 chip resets when switch to the DFU mode. All the GPIOs are turned off during reset. However, one of the...
