Our pcb is used for gps location data. We have a nrf24L01 nordic chip as the micro process or between the gps module and wireless module (2G). Our engineer needs to capture...
Hey folks,
I'm trying to modify the SPI Master loop back example into a 4 line SPI Master_Slave program. Whenever I change the Tx_Buffer_lenght from 10 to lsome other numbers...
Hi.
I am using S130 softdevice version.
Basically, I am using NUS Service and make a my own NUS central service as NUS_C.
It is correctly work at normal state.
When...
Hi All,
Please Reviwe for a attached circuit file(Chip ANT of nRF51822.pdf).
I also attach a datasheet of chip antenna applied for that circuit(SDBTPTR3015 Data Sheet...
to me it made sense that EN_AA settings are controlling the receiving pipes if an ACK has to be sent back upon receiving a valid packet.
then i thought that the settings...
I am using BLE_Gateway example defined in nRF51-ble-bcast-mesh to create an rbc_mesh over 2 nRF51422 devices . For now, I am just testing it out on 2 nRF51422; I will set...
Hello,
I see when you import an example from the pack installer ( for example pwm, ble, timer examples ) it arrives with the misc controls --c99 on by default , so I cannot...
Hello there,
So we are working with a sensor that needs to receive a pulsed voltage, so we are using a PWM signal from our nrf51-DK applied to a transistor based circuit...
I want to be able to read the gyro and accelerometer values from the MPU6050 sensor.
As a base start I downloaded the nRF5 SDK v15.3.0 and modified twi_sensor_pca10056 program...
Dear support,
We have built a ble mesh network running the light_switch_client/server application (mesh sdk 3.1.0). We are using the Android application for provisioning...
I want to disable and enable interrupts for Rx data, I tried following code to disable interrupt for rx and disable rx. Also TX and RX pins are short, i.e. loopbacked. In...
Hi,
I was wondering if I could get some guidance (or directed to some documentation on the subject) with regards to what socket operations are safe to do in a-sync timer...
I'm trying to use LTE and GPS in the same project. I know I cannot have LTE and GPS running concurrently, but I tried implementing edrx so I could get a GPS fix and alter...
Hello!
I bought recently some nRF52840 (PCA10059) dongle's and one nRF52840- DK. I want to create a kind of network ( a mesh network) from those dongles and communicate...
I cannot see CRASHLOG with RTT viewer but can see CRASHLOG dumps when SES ide debugger is running.
Is there anything different from the SES ide debugger's dumb terminal...
Hi I am working on modify proxy client switch example from mesh sdk version 2.i done some significant changes into code for sending string message rather than 1 or 0.but when...
HI,
AT command not working when network mode is "NB-IoT" in "mqtt_simple",
If network mode is "LTE-M" then AT command is working fine.
Snapshot with network mode is...
I want to be able to read the gyro and accelerometer values from the MPU6050 sensor.
As a base start I downloaded the NRF5 SDK V15.3.0 and modified twi_sensor_pca10056 program...
