Hi,
We're looking for a low-latency 2.4GHz solution (not BLE) and the nRF51822 is oft-quoted as providing low latency, but what are the typical ms figures we could achieve...
Hello all,
in my previous question (Switch between applications (multiple services.h)) I got the advice to merge my two services into one service, including a HID over...
I am trying to create an nRF8001 based application that will broadcast battery levels (pipes broadcast, set), and give out temperature data (pipe indicate - TX_ACK) to connected...
Hi,
I'm using redbearlab's nrf51822 board. It is a arduino compatible board and hence it is using 0,1 (mapped to 9 and 11 for nrf51822). How do I make printf print to this...
An external PA/LNA is used to extend range of nRF51822, and S110 is used for BLE, How to switch between PA and LNA? and how to disable PA/LNA when there isn't transceiving...
Hi...
Can anybody help me to run ble_peripheral example (ble_app_hrs for S130). I have build and load the code successfully but cant see the advertisement. But while debugging...
I am trying to port Keil code to SES 3.40 with NRF51822 Device and SDKV12_3, I am currently using the ble_app_uart example. I followed this blog post https://devzone.nordicsemi...
Hi Sir
Is it possible write a hex file to external QSPI flash by nrfjprog ? if yes, please tell me what's the command ? Thank you.
ps, the hex file is data, not firmware...
We are using nRF52840 SDK 15.0 with Segger embedded studio. We have referred ble_app_proximity example only for read battery level using ADC. Now in our application used SAADC...
Hi, I m using nrf 51822 development board. I want to implement timer in input mode to detect falling edge of the pulse.. It should give intrude when any falling edge is detected...
Hello
I am a big fan of Zephyr OS, and have developed several commercial products with it (on other NRF chips)
I would like to know if the nrf9160 is to be supported...
Hello, I would like some guidance on how to create a standalone executable for nrfutil (like nrfutil.exe on Windows) in order to update my hardware through OSX. Very newbie...
Hi,
I need some clarification about how to create multiple Timer functions?
my application is to
1. read the VDD supply for every 10 sec
2. after BLE connected to...
Hi,
I'm trying to run fatfs example in sdk. I only changed the spi pin numbers. What is wrong with that?
Here is RTT screen.
My schematic is; CS-------------P0.08...
Hi,
I know I have been asking quite a lot of questions lately, so I hope Im not too annoying ;)
my application currently runs very stable (no hard faults or whatsoever...
Hi,
I know I have been asking quite a lot of questions lately, so I hope Im not too annoying ;)
my application currently runs very stable (no hard faults or whatsoever...
I try to active the serial example in the nordic folder nRF5_SDK_15.2.0_9412b96. When using RX_PIN_NUMBER 8, TX_PIN_NUMBER 6, CTS_PIN_NUMBER 7, RTS_PIN_NUMBER 5, HWFC true...
Hi all,
I am learning about the combination between Bluetooth mesh and NFC. I would like to realize a simple exercise below.
Assuming that I have a mesh network with 4...
