Hi We have an application where we what to read i2c sensor data over the air to an iPhone. We've taken ble_app_uart_S130 project and grafted in some twi_hardware code. There...
I am interested in the S130 ability to hold 3 central -> peripheral links over BLE, and am looking for some evidence that this has been accomplished with extremely low-power...
I'm trying to implement channel scanning in our nrf24lu1p based USB dongle.
I'm following the specs and basically loop though each channel ;
loop
stop listening
set...
Hi,
I am using the NRF8001 in UART mode and attempting to bond with my android device (Lollipop 5.0 Nexus 6).
i am using the nordic arduino sdk which is found here:...
Hi, I'm using the nRF8001 in an application that requires security so bonds to the remote client/central. My device supports firmware upgrades that may involve new nRF8001...
Hello.
Initially when reading the Gazell documentation I didn't think it'd be a problem but now in Keil seeing this has introduced some doubt whether it's a thing:
...
Hi,
I use DFU secure_bootloader pca10100e_usb example to modify to nrf52833 DFU.
But when I execute, I get stuck in this line, as shown below.
In configuration, I...
I am changing the Tx power successfully with sd_ble_gap_tx_power_set(). I can see the RSSI value change Nordic Connect to confirm that it really is changing. But I also have...
Hello Nordic Support,
I am using nRF52840 with SDK 15.3. I am running the USB CDC ACM in bulk transfer and interrupt. My nRF52840 plays the central role, it will send strings...
Hello,
I am merging the pb remote with light control example. Both ran fine when I tested separately. Then I began to merge the two. The server is fine when I merge the...
I'm working with a custom board that is using a nrf53840. The SDK is 16.0 and SoftDevice S140 version 7.0.1. Programming with SES. The board has various devices such as accelerometers...
Been scratching my head over this one for a few hours..
I am testing out the AWS IoT library in version 1.3.1 of nrf Connect SDK. Connect, subscribe, and ping are all working...
Has Nordic evaluated their code to see if BLESA is a problem?
https://www.zdnet.com/article/billions-of-devices-vulnerable-to-new-blesa-bluetooth-security-flaw/
Hello,
I am trying to set product identifier and product version in application hex file, then bundled this hex file in zip using nrfutil tool, and performed dfu, then I...
Hello,
I want to use BSDLIB in my application. According to documentation ( https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/nrfxlib/bsdlib/doc/ug_bsdlib_porting_os...
I've developed a little test application on a nrf52832 chip to run fstorage in a bootloader memory address. I followed the nordic guidance to set up, build, and install a...
Hello, The card has already been assigned to an NRF Cloud account. However, we wanted to change the account card for a practical reason. We have therefore deleted the card...
I tried using nrf52832(as slave) communicate with stm32, it successed .
But when I changed nrf52832 to nrf52840 to do the same thing, it failed .
I use the nRF5_SDK_15...
Hello there, I following the nRF IoT SDK getting started and after Connecting Devices to Router section I succeed in connecting devices to router.
After that, I edited...
