We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello, I have a very strange problem with my nrf52-based custom board.
After a bunch of successful programming cycles I am unable to program the board again. The firmware...
hi support team，
how to select network manually, using “8.1 PLMN selection +COPS” or "8.16 Mobile network operator %XOPCONF", which command should customer use, and what...
I am trying to implement mesh with NRF SDK V17.
But nrf5_SDK_for_Mesh_v5.0.0.
When I build the light_switch application, I get the error "boards.h No such file or directory...
Product info:
NRF52840
nRF5_SDK_17.1.0_ddde560
s140_nrf52_7.3.0_softdevice
I am working on a product with a NRF52840 and SDK 17.1.0 and a cell modem. This product...
I'm having no luck in getting JLinkExe or nrfjprog to see my BMD-350 device on my custom PCB.
I have read though all the threads here that reference similar issues and...
Hi
Because the nRF52 SDK doesn't support scheduler server modeI and scheduler setup server model, but I need this model, and I don't know how to implement by myself, could...
As referenced in a previous ticket: devzone.nordicsemi.com/.../nrf9160-mqtt-simple-example-configured-to-talk-to-test-mosquitto-org-using-mutual-tls-on-port-8884 We are seeing...
Using nRF Connect SDK v2.0.0 on Windows in VS Code. Hardware is a U-Blox BMD340 demo kit with nRF52840.
We've built and run the following OpenThread sample applications...
Hello,
I am trying to use http requests on Thingy91 and therefore I tried with the sample from zephyr/samples/net/sockets/http_client.
I can build the project without...
I have a conexio stratus board that I would like to debug the modem with the LTE Link monitor. I am not using the Zephyr frame work, but I can flash pre-compiled hex files...
There's a few threads out there with similar questions, but I haven't seen a direct answer to this.
If I build with nrf5340dk_nrf5340_cpuapp, can I use the entire application...
