We would like to be able to calibrate the rRF9E5 ADC
Our proposal is to permanently fit voltage dividers, each using two precision resistors, on two of the ADC Ports and...
At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hi,
I have experience with the ESP 16/32, pi zero and BOSH XDK. I have been working on some IOT mesh stuff and I have a good product idea that I know I can build with your...
Our project is using SDK 15.3.0 on a nRF25840. Similar to this post , we'd like to be able to re-bond if the bond has been deleted on the Nordic side but not on the phone...
Hello,
I want to test nrf5340 external lfclk, but I don't how to test it.
sdk:1.5.0
board: nrf5340dk without hfclk
I want to use external lfclk to generate 1khz...
Hi Team,
I am developing a device using nrf52832. I want to configure the gpio used to wake up from system off mode to enter into gpio interrupt handler on wake up. How...
Hi ,
I need to add an I2C device in project , I referred sample project i2c_scanner .
changes done in nrf9160dk_nrf9160ns.overlay file
code added in prj.conf
...
We are using PPK II with nRF52840-DK and in zigbee case we are getting two different kinds of reparative pulses
1. Pluse_1 -> Amplitude = 17.52mA ; Ton = 200us & Toff =...
Hi All,
We found a problem about the NRF52832AA connect parameter update problem on some cell phones.
1. While the app connect to our device, parameter update not only...
I'm doing a load test on radio. In 1Mbps mode, the transmission time of the radio with different loads.
For a packet size of 65 bytes, I used this test:
Use the logic...
The crux of the problem is that my Zephyr I2C port is getting locked into EBUSY, and
What are possible reasons for this
How do I fix it
Context:
I'm currently...
Hello,
I am using an I2C sensor with my nrf52832 board and if I do the sensor_sample_fetch(dev), I get an error code of -16.
What does that mean?
Is there a table to...
