I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hello!
So I can connect, disconnect and write to my applications characteristics via a PyQt5 GUI I threw together. On the python backend, I use Bleak to
search for devices...
Hi, I am developing using nrf52832 and st7735s.
Successfully displayed the lcd screen using the code in \examples\peripheral\gfx
However, when screen clear, text_8print...
Hi We want to do range testing using our product and an nRF52832 development kit. We've purchased an external antenna and a connecter in order to extend the range compared...
Hi,
im using sdk 17.1 with segger embedded studio v6.2a and nrf52840. I am trying to use the uart example and it gives an error no name type found "__printf_tag_ptr". I...
I want to add compiler flags to my build configuration i.e _DEBUG, etc
My understanding is that a build is done by build task
nRF Connect extension allows to create a...
Hi, getting this not very descriptive error when trying to upload hex file. I've made the .hex file in platformio. Sounds like i'm missing some software?
Any clues?
Device...
Upon freshly installing NCS and VS Code (to solve an earlier problem), I get the following error when trying to create a build configuration for my project in VS Code: usage...
Hello there,
I'm trying to connect to the AWS cloud. However, when I attempt to connect, it gives out error 128. Which, accoring to this table, means there's no connected...
Hi,
I have seen that by reducing over-the-air bit rate, we can increase the range!!
1. Is this claim aacurate in the case of OpenThread networks?
2. If so, how can...
Hi,
I have an application that we are migrating from NCS v1.7.0 to v2.2.0. With v1.7.0, I was able to build, flash and monitor using VS Code (on Windows 10). The SDK has...
Hello, guys!
We are using nRF51822 SoC with nRF5 SDK v12.3.0 and s130 SoftDevice. For the devices in the wild, we would like to implement the following health monitoring...
Hello, I am looking into using zephyr with a host controller configuration on separate chips, where the controller is an nrf52832 chip. I was wondering how would the power...
Complete error:
C:\ncs\v2.2.0\zephyr\include\zephyr\drivers\gpio.h:1090: undefined reference to `__device_dts_ord_23'
I am an absolute newbie to device tree, so I was...
I am using nrf52840 DK with the Connectivity file "connectivity_4.1.4_1m_with_s132_5.1.0.hex" and the soft device "s140_nrf52_7.2.0_softdevice". I am using the pc-ble-driver...
For some reason get the crazy error.
Using: SDK17.0.2 and S132_7.2.0
Im writing 9 entries into a single file, here is a short log:
00> <debug> app: Datalen: 4
00...