Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
I want to use P2.00,p2.02,P2.04, P2.0 for UARTE20 on NRF5415DK.
This is to use the uart as an interface for HCI uart with NRF54 as the BLE controlller.
How to enable the...
I am setting up our production facility in India. Brought out our test jig software that flashes the nRF53 modules.
I use nrfutil to program the boards via "nrfutil device...
I am using the Thingy91X kit, and I am trying to make a sample 'hello_main" to work on the nrf5340. My project configuration is as follows:
Sample: zephyr/samples/hello_world...
Dear Experts,
We are bringing up a custom nRF54LS05B module and have built a small production-test firmware on top of the `radio_test` sample. While characterising current...
ncs\v3.4.0\nrf\scripts\generate_psa_key_attributes.py doesn't seem to support X25519 PsaKeyType and allowing it to be used with ECDH algorithm. Is this just functionality...
Hi,
We are exploring using the Firmware Loader to do the OTA for our firmware. As per what I understand from the documentation, the Firmware Loader application will be booted...
I have new Thingy 53. Default Edge Inpulse demo works without any problem. But I have problem with Weather Station demo.
First I tested Zigbee version. After flashing using...
Good morning everyone.
I’m having some issues compiling my firmware using NCS 3.4.0 and the ‘ns’ option. I’m using an nRF9151DK board. Basically, my firmware compiles and...
NCS version: v3.3.0 (behavior also confirmed present on current sdk-nrf main, include/flash_map_pm.h).
THE ISSUE
include/flash_map_pm.h selects which PM partition...
Hello there,
In the Zephyr docs i can see theres a typedef for i2c_callback_t but looking through the SDK, i cannot see a any uses for this type.
i am trying to create...
We have nRF54H20 with IRONSIDE (SDK3.2.4).
RESET button has default configuration - connected to DEBUG MCU:
We need realize external HW reset of the DK by another...
Hi，
Does it possible to achieve that when inserting a USB into nPM1300, the GPORESET of GPIO3 is triggered to reset the reset port of nRF4L15?
Best regards,
Peter.M...
Enviroment : nRF52833, ncs v3.1.1
The custom board is connected to a DCDC and a 32.768kHz XTAL. However, during the module manufacturing process, the DCDC and XTAL are not...
