Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
I am from India. Recently I have purchased Thingy91. I have registered IBasis SIM as mentioned in the user guide. While registering the device in the nrf cloud I am facing...
Kind folks,
Attempting to install the Nordic Connect SDK again after failing several times before. (Always seem to have something slightly wrong in my installation which...
Is it possible to have 2 timers (TIMER3 and TIMER4) with the exact timer value?
I need to have two gpios toggeling at a difference time frequency but based on the same clock...
Hello,is the 3.9nH inductance and 0.8pF capacitance in the official routine the impedance matching of the antenna, or do I need additional antenna impedance matching?
I am designing the RF matching network with an IFA antenna for the nRF52811-CAAA.
ANT output may be DC coupled to ground with the IFA antenna or do I need a decoupling capacitor...
Hi folks,
We have a project based on an nRF52833, on a custom board, running at 1.8V. There is no Bluetooth (so no SD usage), and the HF and LF clocks are running from...
I connected nrf52833 with a button and a LED on breadboard, using ble_app_uart example to send message between phone and board. How can I make a function that whenever I press...
Hello Nordic community,
I am using nRF52840 and try to implement external memory unit for MX35LF2G14AC, which is 2Gb SLC NAND flash. I am wondering nRF52840 can support...
For example I want to turn on LED whenever I send 'a' text from my phone. How could I do cause I do not know where a message is stored. I am using ble_app_uart example
It would be useful to read and write other local files apart from the default 'logger', say, to maintain separate custom logs for multiple discovered devices. However modules...
hi,
I coded BT832AF module using nrf52832 eval board and i get the bluetooth device name but i'am not able to connect to BT832 device using nrf tool box it keeps on connecting...
I need a gpio to control an external peripheral.
I thought to code should be similar to controlling one of the leds.
board overlay:
&gpio17 { status = "okay" gpio17...
Hello ! When I run the direct test mode example found in "nRF5_SDK_for_Thread_and_Zigbee_v4.1.0_32ce5f8" in transmission mode, does it only transmit packages on a channel...
Hi,
What is the correct way to write to UICR at runtime?
I am using the code below but the MCU crashes on the first line with no call stack trace.
NRF_NVMC->CONFIG ...
