Hi every one !
I am trying to get working a code that it was working "Ok" 2 years ago.
Currently, I cannot get communication between both breakout boards.
To simplify...
I'm trying to solve an intermittent problem when using the nRF51422 UART with CMSIS-RTOS (RTX) and MDK Networking library (V6.2) (TCP/IP stack).
My questions relate to...
Hi...
When i was working in SDK v6.1.0 i have tried nrfprog.exe to merge and program bootloader, softdevice, application and bootloader_settings file as explained in devzone...
But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
Hello Nordic Engineer,
Actually, the phones are not part of the mesh network, right? Also, I treat all the nodes inside the red box as LEDs because I'm designing...
My own 52833 board use QFN40 package. DK use aQFN73 package.
I try the same code. and find DK can enable exernal xtal. while my own board cannot enable external xtal.
...
Hi,
I have an Adafruit feather nRF52840, and try to program it via a Nordic DK (through the connector Debug out). It is possible to flash the feather when I use a devicetree...
Hi support team,
I'm currently developing a project for a custom board with a nRF9160 chip and with nRF Connect SDK 2.9.0 and Zephyr 3.7.99 using VS code with nRF connect...
Hi, I'm implementing the DFU for the nRF5340 MCU and now need to set my private keys to be able to sign firmware files.
The issue is related to the Signature key file specification...
Hi,
The nrf connect for desktop extension in VS code is not loading anything under welcome, when I try to open the documentation or any other nrf related command it says...
Hello Nordic Engineer,
I tested the mesh functionality with one phone and the 52840 DK, and the DK is running the official mesh_light example. It worked successfully,...
Hi
I have a fully functional addressable LED driver interface using I2S + app_timer. This code has been functional for a long time by itself.
I just added the SAADC example...
First to contextualize my situation, I am in Brazil, more specifically in the city of São Paulo. When the development kit arrived, I immediately did the recommended initialization...
I am trying to send data from icm20948 sensor from the sensor node to the observer node using ble mesh. Due to the data from icm20948 is too large (9 uint16_t, 18bytes) for...
Hi Nordic community, I have received nRF7002DK device and trying to make it work on v2.9.0 sdk. I'm working wifi sample project,successfully building and flashing in the device...
I have installed the nRF Connect SDK, with both the toolchain and SDK set to version V2.9. I selected the nrf54l15dk board for development, but I do not have a physical nrf54l15dk...
Hello ,
I have taken reference project which use all leads and buttons of Evaluation module NRF52833.
I want to create overlay file for this project and remove few led...
