Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
Hello,
I am developing my own application using nRF Connect SDK with the nRF5340.
I want to drive multiple GPIO pins at the same time using the function gpio_port_set_masked...
Hi!
I am working on creating a Low Power mesh network and am trying to decide which communication protocol I should use with the NRF52840. There are no nodes in the network...
Hello,
I'm using NCS 2.0.1 on a nRF5340 board.
Currently I have some troubles with getting a response if I try to write a BLE characteristic from an iOS app. The write...
Hello, I am trying to disable using uart for console use Kconfig.
I am using sdk v2.0.2 (VSCode + nrf connect extension)
It works and the software works as expected. After...
Hi,
I would like to know how I can get the connection parameter in nrf connect for desktop. I want to assign the same parameter for our pc-ble-driver-py program.
Good day to all
I am at the final stages of developing a program for collecting sensor information from a UART and publishing it onto a mqtt server. Currently the device...
Hi All,
I am using nRF5_SDK_17.1.0
while building SDK example project uder the below path with SES
..\nRF5_SDK_17.1.0_ddde560\examples\dfu\secure_bootloader\pca10100_s140_ble...
Hey!
Would it be possible to use I2C and SPI simultaneously on the nRF5340? I'm using I2C/TWI for sensor data (optical based) and SPI for a DAC - need both of them operating...
Hello,
I'm doing a few power consumption tests on the nrf9160 DK with NB-IoT for a battery powered application. PSM mode works as expected but I measured a current drain...
Hello, I am looking to cheaply flash a nrf5340. This will most likely be a one-time thing, so I don't want to invest in a J-Link device.
I have an ST-LINK clone though and...
Hello Everyone,
I need help in the integration of MPU6050 with nRF52840. I know inside SDK one example is present but it worked with nRF52832DK. when I tried to build it...
Hi!
I am attempting to configure a nrf5340 dk as a central to receive BLE notifications. The code is based on the central_hr sample.
The notifications i am attempting...
