This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hi while implementing Media Transfer Protocol MTP I wanted to know how many bytes were transmitted by the host on EPOUT. I had to do a bit of research and trial/error - I...
Hi,
SDK : nRF5_SDK_15.2.0_9412b96
I want to perform pairing between mobile app and a device NRF52832 device based on the device serial number.
In other words I want...
Hello,
I come to you because I wanted to recover the GPS data in my project for that I based on the sample agps, however when I launch my project at the time of the reception...
Hello
I had integrated the DFU client stack in ble_thread_dyn_hrs_coap_srv_freertos project.
SDK : nRF5_SDK_for_Thread_and_Zigbee_v4.1.0_32ce5f8
After clearing all the...
I send AT command:
AT+CPSMS=1,"","","10100010","00100001" Which means active PSM mode with TAU time = 2 minutes, RAT = 1 minutes. I receive: CEREG: 1,"61E6","090A8C15",9...
Hi,
I'm busy evaluating an application right now, I would like to ask whether Bluetooth Mesh can be realized or other solutions can be provided.
A terminal device, similar...
Hi. We are currently working with nrf52 SDK 15.2\.3 and wish to move to nrf-connect-sdk with zephyr BLE MESH stack We are using several peripherals on nrf52840 which i'm not...
Hi,
I have a peripheral, that should connect to a central automatically. The problem is, there might be multiple
centrals with the same target name available and the central...
Hello, I made a new project at SEGGER for nRF5340 and in the first step before do any development I face with the attached error! The file it asked doesn´t exist !! Could...
Hello DevZone support team!
We are right now doing GCF certification of a device based on nRF9160 and need some urgent support from You!!
Attached is an excel sheet with...
Hi, I need more information about the GPS Chipset used in NRF9160 SIP or give me the name of this GPS module, so I can find its spec on the internet. Thanks in advance
I'm trying to activate because I want to use the HKDF of the nrf_oberon library. But when I try to compile with CMake and the target zephyr_final I get the following error...
Hello,
I am currently trying to program the nRF52832 to be able to receive data from a heart rate sensor. The sensor uses I2C communication and has an additional two pins...
Hi,
I am using this SDK: nRF5_SDK_15.2.0_9412b96 with NRF52840.
Having a disconnection issue where the device disconnects after one hour, If there is more devices connected...
