Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
Hi,
I have developed a custom application on nRF54L15 and now I want to add OTA over BLE support in it.
For that, I am following Exercise 5 – FOTA over Bluetooth Low Energy...
I am trying to setup the dev. environment in OpenSuSE Linux, but, even though it says Linux, I only find support for Ubuntu.
I am blocked now setting connecting the board...
Hello,
I'm designing an application where I intend to authorize different users to access the functionalities of a device based on the nRF54 family.
The general idea is...
Hello, I'm using NFC Type 4 Tag (T4T) but I can't write to it. The tool I'm using is the nRF NFC Toolbox. From the app screen I generate a Record and then touch the tag to...
Good day, I'm trying to use pin 1.02 as a GPIO in a TF-M build using a (custom) non-secure board target, and I'm struggling to find the appropriate way to accomplish this...
When I first created the BLOB Transfer model, I had to analysis the DFU sample code because there was no BLOB Transfer model sample.
Is it possible for me to create a sample...
Hi, For supporting multiple different peripherals is it possible to get something back from a SoC observer which indicates the peripheral type? https://docs.nordicsemi.com...
We have a manufacturing project assembling the 0.35mm CSP package. We would like guidance on part handling, solder stencil specifications and any other process steps that...
I am developing a DFU (FOTA) feature via BLE on the nRF54L15 MCU using NCS v2.9.1 .
I am using MCUBoot direct-XIP with revert mode .
My application needs to detect the...
Hi Nordic Team,
I’m working with the nRF9160DK , specifically targeting the nRF52840 application core ( nrf9160dk_nrf52840 ).
While building a BLE Central application...
Hi Nordic team,
We’ve implemented a custom firmware update flow for our nRF5340-based device , which supports a robust single-image FOTA process using external NAND flash...
In our design, we wired the SD card in SPI mode on SPI bus 4 wich a maximum SPI frequency of 50 MHz or 25 MHz as these are supported by the SD card. We used FAT32 file system...
Due to board design flaws that led to insufficient rise time for 100kbps communication, I would like to configure my i2c node in the device tree with a baud rate of 10 kbps...
Hi, I previously saw in open threads that it was possible to retrieve I/Q samples from the BLE chip inside nrf9151 DK in order to save them. I would like to reproduce this...
