After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
Hello Nordic Support Team,
I have a problem with establish encryption connection between nRF52 device and Windows 10.
My nRF52 Device supports pairing, but not bonding...
Hi,Master:
Question 1:
As shown in the below, why does the api read this variable with critical protection?
Question 2:
Suppose two tasks have write operations...
Hi, 1) I need to test the frequency accuracy as well as the spurious emissions. I have been trying with the Radio_test example but it needs some special UART configuration...
We have developed a project for the customer. In order to obtain longer battery life, we need to save power consumption, so we turn on CONFIG_DEVICE_POWER_MANAGEMENT. In order...
Hi teams,
Recently I have bricked my PCA10059 dongle by accidental writing PPK2 firmware to it.
I have read several recovery documents including https://devzone.nordicsemi...
What is the proper way of enabling / disabling flow control with the nRF Connect SDK? I've tried adding 'hw-flow-control;" as a flag to the uart0 define in my primary dts...
Hello to the community!
We are using extensively the PPK2 in our test automation.
I do not want to sound like a salesman, but I want to give our testimony: The PPK2 is...
Hello everyone,
I recently got a nRF52840 DK and have set up nRF Connect + Visual Studio Code (running on Linux/Ubuntu based system).
I went through the Getting Started...
I have a strange problem and I am not sure if this is actually correct behavior or if I am doing something wrong. So we wanted to dive into BLE deeper and bought two Nordic...
Hi.
I'd like to make use of CMake's presets, but it seems like nRF Connect for VS Code is forgetting about my presets when I hit "pristine build".
I've created an application...
Nrf52840 uses usbd_ hid_ The demo of composite is written in sdk15. It can only be recognized by the computer after pressing the restart key or power off for a long time....
Hello,
I'm having an issue with attribute reports on change for the string data type.
I have my custom cluster created like the following:
For the string attribute...
Hi,
i'm running the Heart Rate collector example and have a question. What is the expected behaviour? From the description on the infocenter I read that it should print...
Hi,
My configuration on SEGGER Embedded Studio for "Open nRF Connect SDK Project..." is the following:
nRF Connect SDK Release: 1.5.0
Projects: serial_lte_modem
...
