After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
Hello Nordic Devzone Community,
I'm having some trouble install nRF Command Line Tools on a 64-bit Linux host. From Nordic's page www.nordicsemi.com/.../download I've downloaded...
Hi everyone,
I am working with a custom board fanstel bc840, which use nrf52840, and it is configured like this video explain https://www.youtube.com/watch?v=KSivO9Cf1TE&t...
Hi,
Im seeing some parsing errors and even though everything seems to work fine regardless, i'm afraid it will come back to haunt me at some point. Spec details are described...
Thingy with iBasis or Poland-Orange SIM doesn't register to network.
There is a good GSM signal in my area and few towers in line of sight.
I unpacked Thingy and followed...
Hi everyone,
I am working on nrf Connect 3.7.0, SDK v1.6.1 with a nrf52840.
I am not able to change the filter of scanning, only works with UUID filter.
static int...
Hi!
It must be something stupid from my side.
I'd like to add new device ( first one ) on Dashboard. According the manual I should press on green add sign, but there is...
Error message: "CONFIG_NET_CONFIG_IEEE802154_DEV_NAME" undeclared (first use in this function) - appears when I try to build the solution from the sample: coap_client on my...
Hi,
I have a mesh provisioner with the provisioner example in the mesh sdk. When I try to provision a device that is next to the provisioner, all works.
But when I try...
I want to send sensor data using sensor_server_status_publish function, however struggling with data marshalling. I get unknown property ID or no data at all displayed in...
Hello
I am using sdk v17 and nrf52dk and implementing sensor encryption(AES CTR mode) and simple nus service. After reading the sensor to saadc, I want to encrypt and transmit...
Thanks in advanced. I'm using nrf52832 with nRF5_SDK_17.0.2. I try to measure adc time consuming as below:
I find when timer sample rate is 500ms, then adc time consuming...
Hi:
I am doing a project which will use both PDM interface and bluetooth transreceiver, PDM interface is used to receive audio data from a MEMS microphone and Bluetooth...
