Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
Hello,
I am receiving errors due to the ambiguity in selecting the correct tag.
There is no secure boot in the current nrf version i am using at the moment which...
Hello guys,
I am currently playing with the usbd_msc example from SDK15.3.0 that use USB Class storage module.
I was able to drop some files from my PC to 8MB drive...
Development software : SES 4.16;
Computer platform: macOS 10.14.4;
Hardware: nRF52832QFAA.
Hello everyone~
I'm trying to use the nrf_drv_twi APIs to drive the sensor...
Hi all,
I am using SDK for mesh v. 3.1.0 next to SDK 15.2, nRF52832 DK. I have two services, NUS and Mesh Proxy Service. For both of the services there is registered a BLE...
I have a nRF9160 DK and I'm adapting the asset tracker to connect to our own AWS cloud solution.
I see the code nrf_cloud uses defines coming from the Kconfig at \nrf...
Hello!
I am wondering what the impedance looking into ANT pin 30 is for the NRF52832 WLCSP package. Does the recommended 1pF shunt and 3.3nH series transform the pin impedance...
I have a custom built multimotion sensor that is using NRF52840 and is setup as a sleepy Zigbee end device, however I can not find a way for it to poll its parent less frequently...
Hello, I was trying to run PDM microphone example code for Thingy:52 on my own PCB with nRF52832 chip. I was struggling a lot and can't even start PDM clock, using some free...
Some models such as the Time Server requires that certain messages are sent with a TTL of 0. (See 5.3.1.2.2 Sending a Time Status message). However, not all messages sent...
I'm migrating from SDK 14.0.0 to SDK 15.0.0, due to Migration guide I have changed my `advertising_start` function so it looks as follows:
However I got an error 9 for...
Hi,
I am new to the nRF world of controllers. I am planning to use these wireless MCU for our IoT enabled products. We are in the early stages of finalizing the MCS, so...
Hi,
I'm including additional C libraries into the asset_tracker sample and have already hit the wall exceeding the space allocated to FLASH
Memory region Used Size Region...
I've noted an odd bug in the SAADC specifically with the Low Power Mode enabled. I used the SAADC to either gather data via Timer+PPI during a data collection mode, OR polling...
Hi,
I'm working on audio codec(ES8374) which using I2S to transfer data, and this part is fine.
Since project require low power consumption, All peripheral should be closed...
