Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
When using the BLE device, BLE_GAP_EVT_DISCONNECTED event informs us that connection between dongle and BLE device was closed/lost.
Is there a way to know when dongle connection...
I am interfacing nrf52840DK to a SPI module soldered by myself on a custom PCB adapter, connected by wires. This is the init code:
I have two issues with the default...
Dear Colleagues
SoftDevice API has event NRF_EVT_POWER_FAILURE_WARNING but is missing something like NRF_EVT_POWER_RESTORED
My application needs to quickly check if power...
nRF52832-QFAA-0E, S132
With DCDC, UART and SoftDeivce enabled my ammeter shows 1.3 mA, but when app calls sd_softdevice_disable() current actually increases to ~4 mA
The...
Hi! Im just getting started With the NRF9160 DK. I have followed the instructions on "getting started Assistant" for NRF Connect (Windows 10). when im trying to build my Project...
I have a working/functioning project running on the nRF51 dongle that I want to develop for production. To save a step in FCC certification I am developing on an FCC approved...
Hello,
I am currently attempting to include mesh functionality in a bootloader so as to have it do DFU over mesh without the serial port. I keep getting errors when trying...
hi..... i am using nRF52832 and segger latest version 3.1 mesh sdk
i am trying to send the message from client to server side using light switch example , I have made some...
I'm testing this with SDK 15.2 on an NRF52832, with SD132.
The documentation says: "When the space is exhausted, write requests return the error FDS_ERR_NO_SPACE_IN_FLASH...
HI all
I am facing SPI cofiguration issue on nRF 52 DK.I am using PAJ7025R2 sensor and will act as a slave, and nRF52 acts as a master.Currently i am not getting any data...
Hi,
I would like to program a ble basic program on nRF51822 chip. I have Keil uvision MDK 5, ST Link programmer, SDK 8.0.0 and S130 softdevice + a third-party development...
Hello,
I have developed a prototype that uses the nRF52840 Adafruit Feather Express, a few sensors, and some other components. I am somewhat new to hardware engineering;...
Hello,
I am looking for (10) pieces of the tiny nRF52810-CAAA for a prototype.
Apparently, distributors do not yet have any stock and the lead time is 14-16 weeks.
Might...
This is probably a very easy question to answer and I apologise for not fining the solution myself but I have been trolling through the documentation for several hours now...
