Hi
I have my code like this .
unsigned char *encryptedData;
unsigned int encryptedDataAfterAppendingLength;
memset(encryptedData, 0, encryptedDataAfterAppendingLength...
After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hi
We are using your product nRF51x22_QFN48 with a balun BALF-NRF01E3 from ST and the PA.11 antenna from Taoglas Ltd.
Do you already have this product certified for RED...
Hi guys,
We have noticed some unexpected behavior of supervision timeout in case of few fast sequential calls of connect and disconnect commands in nRF connect app with...
hi...
i am using nrf52382 segger 15.2 version , i am facing issues i couldn't able to send the data ,here i am advertising using condition if my condition satisfied start...
Hello,
I use SDK15.2, SES4.12 and custom board with nRF52840.
I have a strip of ws2812b LED's connected to my device. I've made a simple RGB animation, each frame of which...
Hi,
I've been testing the sample code at_clent with Verizon wireless. I can send AT command to the DK via nRF Connect "LTE Link Monitor".
Q1. run AT%XCBAND=? to print...
Hi ,
I found nRF24LU1+ build in AES co-processor, but I cannot found the processing speed (the time for finish one AES processing) on datasheet.
Because my customer...
Hi,
I know this is a stupid question, but I couldn't find any answer in the forum or anywhere, and it is getting annoying :)
I'm using SEGGER Embedded Studio for ARM ...
Hello All,
I am currently working with two boards of PCA10040
One of them is v1.1.1 and the other one is v1.2.4
My code must connect with other nrf52 boards to exchange...
I am using nRF51422 with the SDK 11. I am using the proximity application primarily for the ADC Battery Level Service. I would like to have the device advertise indefinitely...
Hi.
I am working with an nRF52840. How should I call Softdevice API functions from my app?
and more precisely this GAP function:
uint32_t
sd_ble_gap_tx_power_set...
Hi,
I would like to access to the code of a commercial device that contain n51822 and another device with n52832.
Could someone tell me if that is possible or not (Both...
I am using the SDK 11 and nRF51422 device. I have built and run the ble_app_proximity application, however, it does not appear that the device is advertising. I am using the...
