Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
DFU has worked fine until just recently.
Our custom hardware is using the nRF51822 and softdevice 8. We are using non-secure DFU.
We are using the latest nrFConnect. We...
Hi,
I'm trying to flash my device. Until yesterday, this command ran just fine and I was able to flashing my nRF51 chip. But I'm unable to do so anymore and can't figure...
Hello everyone,
I write this post because I haven't been able to find a solution to a problem I'm having to implement a parallel to serial converter. I am employing the...
Hi,
I am using the NRF52840, softdevice: s140, example: ble_app_uart from nRF5_SDK_15.2.0_9412b96.
short description of my application: i am developing an application...
Hi there,
I have been testing with the nrf9160 DK for a while now and I cant figure out how to get the device to sleep properly. I have been working with the asset_tracker...
Hi,
I've installed nRF sniffer version 2-0-0-beta on nRF52832 DK and verified it with BLE Beacon example. It works nice.
But when running light-switch example from Mesh...
Hi Nordic Team
We are working on BLE Modules which includes the chip-set nRF51822 and nRF52832.
We have tight form-factor and want to have longer range communication so...
Hi, I have a problem with waking up a device, description as below.
Application description: I made some application which is based on Serial example - all is working fine...
Hi
What is the default PHY when using NRF52832, SDK 14.2 and SD S132 v5.0?
When does a device's PHY get reset to this default value? Is it upon disconnect or is it as...
Hello,
I'm developing Win32 application, where I have to communicate with BLE device from our customer. At the beginning is simple application level authentication (with...
At the moment I am collecting 64 RSSI values into an array and want to calculate the average and variance of them. I have managed to calculate the average by adding up the...
