Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi everyone,
I am trying to connect multiple peripheral and collect the rssi values of the the peripheral devices in central mode. After collecting the rssi value of the...
I want to send Digital Microphone data from one device to the other two devices. So which BLE and micro-controller should I use for better performance? I am totally new to...
Hello,
I am using nRF52832, SDK_15.3.0, S132 SoftDevice and Segger for flashing the image. I am using ‘ble_app_blinky’.
I connected my sensor to nRF52832 DK over TWI...
when i run this command
D:\softwer\nRF5_SDK_15.2.0\examples\ble_peripheral\DMP\pca10040\s132\arm5_no_packs\_build>nrfutil pkg generate --hw-version 52 --application-version...
Hi, we have several nRF 52 development kit, we are trying to connect it through our mobile phone (nordic semiconductor gateway app) to the nRF connect for cloud. Our problem...
i am trying to compile an example program (BLE characteristics a beginners tutorial ) using IAR . but when i downloaded and extracted the git-hub zipped file. The file doesn...
Hi,
My application only needs to be connected to the network for a short period of time to deliver data to a server and then disconnect again. At first everything works...
I use nRF52832 and SDK 15. Using the PPK, I measure a floor of about 1 mA that stay in SYSTEM_OFF mode. Debugging in more detail, I found that it's due to the UART setup and...
I want to adapt the example light switch with the dongle plate nRF52840. Could Alguein do it?
add to the directory
.. \ nrf5SDKforMeshv310src \ examples \ common \ include...
Hi,
I have two nRF9160 DK.
One of DK start freeze after programmed some applications.
I try to recovery it by "nrfjprog -e" but no help.
I try to install modem again...
Hi,
We're going to develop smart home system with mesh connectivity. So we decide to develop nrf52832 custom module which can plug to several home appliances.
Currently...
Hello Community,
I flashed latest modem firmware in my nRF9160 DK board and my board has version 0.8.5. I am working on GPS example and successfully flashed GPS firmware...