I am sending setup commands to a NRF8001 D device and I receive a command response with status of 0x89. This appears to respond to ACI_STATUS_ERROR_UNSUPPORTED_FORMAT. I cannot...
Hi I'm working on a school project and I need to send data from an accelerometer to a phone I'm currently able to update "dummy" data from my nrf51822 to my phone after following...
Working on an ANT project.
Switched a project from S210 to S310 to add BLE feature.
For the ANT part, there is no source code modification at all.
Sweet.
This is not...
Has anyone experience of successful TICK_DV calibration for nRF9E5? What order of accuracy should be achievable?
In my application I maintain a software RTC clocked by...
Hello,
I manage to work with new S310 V2.
I use S310 for hrm only. Saying so also not for DFU service.
I have own proprietary method for transfering application images...
I am working on an application and need to get the exact time that the master node receive advertising from the slave node. I tried with PPI and it's ok to capture the Radio...
I like to program NRF52840 Dongle without using NRF Connect Desktop (i.e, Normally we develop application program using some IDE) Can i develop application program using NRF52840...
Hello everyone
I started working on BLE devices recently and I have an Ardunio with BLE 4.2. However the maximum data rate seems to be low for my purpose ( about 60 Kbits...
Hi Guys,
I have been trying to port the older nRF51 debouncer_example (attached) into the nRF52 SDK15.2 ble_app_template example with not much luck. I realise that this...
Dear nordic,
1. Is it possible to create thread networking using dongle?
2. I want to create Thread CLI example in dongle but the problem here is UART pins and LEDS. what...
hi ,
I'm a newer , using nRF5_SDK_15.3.0_59ac345. we are using nrf52832 to get about 100 of heart rate sensors.
so first we do a scan ,and get all of there addrs. and...
Hi Dear
We plan to implement our own DFU controller on host MCU, the bootloader+softdevice+app zip file will be generated by nrftutil software.
How to exact those part...
The Capacitive Sensor low-level library documentation says:
Note:
Until Anomaly 84 (ISOURCE not functional) is fixed, the COMP solution cannot provide production-level...
Hi.
I usually used nrf52832 rather than nrf52810 since nrf52832 has an FPU, I rarely considered the computational cost for calculating floating point.
The problem is,...
Just to clarify a bit, I get that the DFU will take ages to propagate though a large network, but the first insertion of the new DFU from, lets say a cellphone, to the "proxy...
Hi, I am using nRF24L01 as a part of a larger project that involves communication between two such transceivers sending and receiving data. I am trying to get a similar but...
Could I get a code sample that shows how to drive gpio pins high on the 52840 chip on my 9160DK so I can modify it to drive analog switches to forward gpio pins to the 9160...
