I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
Using nRF51822, I define keys and pins as follows:
Keyboard key
Mouse left/right key
Mouse move (up/down/left/right)
Media play/pause key
Pin 0 Mouse...
The bluetooth device keeps getting disconnected from the app, even when its not 'idle'.
I am using the android app mentioned here .
I need help getting started to solve...
Dear Sirs!
I am going to use nrf_drv_spi_xfer to read 15 bytes periodically (Approximately each 4 ms) according to GPIO (GPIOTE Event via PPI). To do it I am going to call...
I'm attempting to use a vendor or custom model to deliver sensor data through a ble mesh using a nrf52840dk board. On Ubuntu, I'm using the nrf connect sdk v2.2.0. i have...
Hi,
We are using the nordic sdk 1.9.1.
I have created my own project and i want whole sdk commit to my repo. I am able to build the project. I am not able to commit the...
Hello Guys,
I am trying to implement our own firmware update over ble in Mobile App.
The whole process is succesfully done by Nordic Application (Device Manager).
I...
Hi,
I'm implementing a circuit that uses both ble and usb communication using nRF52840.
I'm configuring power source and i'll configure schematic like reference circuit...
Hi there.
I am currently developing a simple asset tracker based on several examples using nrf9160 custom board.
So I am using several examples like mqtt_simple, gnss...
Hi,
I am using STLED524 intelligent matrix LED display driver IC for my project.I need to interface STLED524 with nRF 52 board.I am checking for driver library for it.But...
Dear All,
I'm implementing a SNTP sync over Ethernet and found the following issues:
1- CONFIG_DATE_TIME_AUTO_UPDATE must be disabled to get a NTP time sync scheduling...
It seems like there are lots of questions regarding simple GPIOs and devicetree, but I can't quite find something that describes my problem:
I am using the nrf52840dk...
Hi,
Our team is developing an application based on the nRF5340-DK - we are developing on the DK while our hardware is in transit. Our schematic largely follows the reference...
I have developed a thread network using nRF52840 dongle and Raspberry Pi 4B. I have checked from the command line of the RPi, the transmit power is 0dBm. Can you please confirm...
Hi,
I use embedded wizard tool to handle display graphic and I need allocate a RAM buffer for it. I need to write frame buffer ram start and size in embedded wizard config...
Hi all,
I want to compile chip-tool so that I can make 5340 into a matter network. But I always fail to compile.
environment:
raspberry pi 4B + ubuntu-22.04.1-preinstalled...
Hello,
I am trying to load an application update from a server into external flash, the download itself is working but mcuboot is not:
I need to use the external flash...
