Hello,In normal condition, I use UART,pwm,spi an so on.Now I want to clear the configuration, and enter System ON mode.But I don't want to system reset.
How should I do...
Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
ncs2.1.0
I have one unit, that somehow works, and when I loaded the code into any other blank devices it crashes.
The kernel panic provides hardly any info, but I'm pretty...
Hello, Nordic!
We are old customers of Nordic NRF52840. We have been using NRF52840 since the promotion of NRF52840. We use NRF52840 to make some IoT modules for our customers...
Hi,
I have been trying to install nRF Connect SDK.
I initially tried installing via the Toolchain Manager as recommended. I have previously used Power Profiler and LTE...
Hello! I've run into a problem after updating much of the environment (cmake, ninja, python, git, etc.) that I can't compile the code in nRF Connect SDK now.
Initially I...
Hello,
I am trying to create two notification characteristics between the nRF52840 and Android app. Though I am able to enable notifications for both the characteristics...
Hello,
after several problems resolved we were quite confident, that the migration to SDK15.3 was successfully completed, but when testing intensively we found a hopefully...
Hi there
I am currently developing a custom wireless protocol for the nRF52805. To do this I am programming the Radio registers directly. In other words, I am not using...
I receive error
I have custom board with nrf52811
my defines in .vscode/c_cpp_properties.json
and my custom MakeFile
I use nRF5_SDK_17.1.0_ddde560 , ARM GCC...
I'm trying to flash the Bootloader sample to my nRF52840 (in order to understand how dfu and ota works).
First I connected the usb cable to the board (at the top of the...
Hello, I am trying to run SPI Slave on NCS with NRFX drivers and for some reason device resets and I cannot figure out why. The code is pretty much straightforward, maybe...
nRF52840 NCS SDK v1.9.1 nRF52840DK
My application is based on the coap_client sample, and is running on the nRF52840DK. It runs fine all alone. I have added code to download...
I want to optimize/ test the power usage of the network search after a network has been lost. I want to try different %PERIODICSEARCHCONF configurations, and measure the required...
Extremely slow scrolling speed. Sometimes taking up to 20s to show current voltages. Unusable. Already downgraded down to version 2.6 of nrfConnect and it still the same....
Hi All. In my final project (Electrical engineering) I'm trying to create a Closed area navigation system using AoA/AoD methods. (e.g., https://www.youtube.com/watch?v=zg9IBP3WRCU...
