Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hello everyone,
I am new and tried some example on the nrf52840 devkit and dongle, including light switch example.
I am now going to send some ASCII bytes through the...
Hi,
The nrf52840 is mounted in our custom board. We found a Jlink programmer , hoping that this programmer is compatible with our chip(nrf52840) to flash the program onto...
Hello! As the subject implies, I'm looking for a Zephyr BLE Long Range Advertiser Example for the nRF52840 DK. Can anyone point me in the direction of one (if it exists)?...
Hi,
I can use nrf21540 to enhance TX power and can see it result, it work fine (The value RSSI in nrfConnect app increase by about 20dbm)
Now, I want to combine both Tx...
Hi, I am working on the mesh serial and run that successfully once using sdk5 for mesh V.5 and nrf52840 devkit and an nrf52840 dongle as a server node. I have several questions...
I am looking into a project that uses a Bluetooth mic and Bluetooth speakers paired to the same computer at the same time. I'm familiar with Bluetooth and with Nordic's offerings...
Assume I have a device running on nRF52840, and two different versions of mobile apps that will attempt to read one of it's characteristics
One version of the app will have...
Hello All,
I am developing project which is based on nRF52840 and uses UART.
This my nRF52840 UART connect to STM's MCU UART.
If I do the connect Rx-Tx, Tx-Rx and VCC...
Is there a sample application for LE Audio using nrf5340 that demos the streaming of audio from say an iphone to several different BT devices (headphones and speakers) at...
Hello
Now I want to do Multiple Advertising. Using 2 channels with different UUIDs One uses Connection to get data. The other one, I'd like to implement a Beacon distribution...
Hello,
In my development process from time to time after adding/changing code I get some Zephyr fatal error. So far I was able to fix all of those errors, but it always...
Hi , I have also tried to user android device as a peripheral to communicate with remote nrf52 device, but due to rx and tx octet mismatching of data symmetric issue , after...
Hello,
I using MacBook
When I use nRF Connect desktop open Toolchain Manager
It shows the nRF Connect SDK v1.5.1 I downloaded
I click "Open IDE" and want to create...
