Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
Hi team,
My customer is evaluating nRF52810 in their project, and they come up with some questions regarding chip MAC address:
1. They understand that chip MAC address...
Hi,
I am using nRF52840 Preview DK with SDK version 15.3
I want to connect to a peripheral and configure some of its behavior such as Transmission power, Transmission...
Hello! I am using nRF5 SDK 15.3.0. The SPIM sck and the QSPI sck pin is same on my Pcb. When i initialized both peripheral SPIM works well ,but the QSPI not works. Is there...
Hi
I'm currently struggling a bit with the zboss API. I am trying to define 2 lights on my nRF52840 DK board. Via Amazon Alexa, it should be possible to control these two...
Hello,
I'm starting design on a new BLE dongle project.
I am planning to use nRF52840 and an external flash memory for storing sensor data. I need to include timestamp...
Somewhat doubtfully updated to DAPLINK, followed the guide re - turning off services/storage service to get this update to work. All looked good.
but board now appears BRICKED...
Hello everyone,
I want to ask whether the NRF51822 can exit SYSTEM OFF mode with interrupt from a timer?
In the user guide I read:
The system can be woken up from...
Hi,
I have developed a application on nRF51822 that is detect eBeacon and read some information in Beacon and Scan reponse frames.
There is about 200 systems deployed...
Hi, I have been working with the nRF52840-DK and the dongle for some time with OpenThread and it works great. I have now built a mesh application which I want to run on the...
Dear Ladies and Gentlemen
We recently received two Bluetooth 5.0 modules, one nRF52840- and one nRF52832 developmentkit. The aim is to use these two bluetooth devices...
It looks like that 1Mb flash is useful for people like me who don't want to worry about external flash. The question I have is how aggressively I can use the storage? It only...
Hi
i have below requirement:
My device acts as central and i am using db discovery module to discover services which are registered using ble_db_discovery_evt_register...
Hi,
I am tryin to erase the DK board using nRFgo studio, but it not detecting the device.
It get detected in SES studio and programmed also. We reset the baord and...
