Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Description of setup/problem.
1 PCA10056 is defined as Central
1 PCA10056 defined as Peripheral.
I have used the “ble_app_uart_c” and “ble_app_uart” examples as starting...
Hi,
I am using SAADC with multiple channels in my application and I discovered data order does change after a debug-break.
To reproduce I used the saadc example from the...
We have an nRF52840 setup as a slave to communicate with a motor controller. I connected a logic analyzer to the lines to confirm the data being sent across. There are 18...
I am testing several phones with a specific App that I connect to my nRF52832. Some phones pair nicely but others do not pair as expected. They display two pairing requests...
I am looking for some sample code, showing how to send cloud -to- device messages to a device from an Azure IoT hub using topic direct method requests $iothub/methods/POST...
Hi,
I am working with the nordic thingy91 on a windows PC, and am noticing unstability regarding the USB serial port. That is:
- After a while, there is no data coming...
I refer to this guide to add dfu to peripheral_uart. The program runs on nRF52840DK.
1、prj.conf
I added the following macros.
CONFIG_MCUMGR=y CONFIG_MCUMGR_CMD_OS_MGMT...
For reading ecg data must synchronize GPIOE interrupt every 4ms,i want to creat a hardware timer with period 4ms, in this timer cb, take semophere gived by GPIOE interrupt...
Hi team,
I want to make simple communication between NRF52840 dongle and mcp2517 CAN FD contoller using SPI. I do not understand, how to send and read values to and from...
The initialized struct "nrf_fstorage_t" for use in nrf_fstorage_init( ) temporarily includes the application and bootloader (just for this test)
start address is 0x2'600...
Hi,
I have setup a provisionner with the sdk example that can provision devices. For that the provisioner scan unprovisioned devices and can start a provisioning process...
Hello,
I am trying to see how the signal strength for Zigbee and BLE changes when the distance between two nR5340 DK increases.
I used central_uart and peripheral_uart...
