hi all ,
how to enable GPIOTE PORT and IN[n] event simultaneously ?(not same pin)
i enable the GPIOTE to trigger interrupt event.
one for the keyboard which need multiple...
Hi All,
I am using nRF51422 with softdevice s310. And implementing Cycle speed and cadence receiver. most of the data processing is fine but i am facing one problem.
...
Hello Nordic Team,
I have a problem with programming the nRF24LE1 chip.
I am developing a small system, which consists of a uC STM32F4xx and a nRF24LE1 Radio Module. The...
Hi,
I'd like to learn about the app compatibility for the new OTA DFU that ships with the new SDK 6.0.0 and S110 7.0.0. I am using a nRF51822 board and I've observed that...
I'm curious to know if there is a tool that allows easy design of a GATT server DB that is portable across dev platforms (the nrf518 EK, my Android/iOS dev environment etc...
Iam trying to display the uart data as a scanned response.nRF51822 receives the data from PIC and it is displayed as scanned response during advertising.the problem is nrf51822...
Hi,
This is a bit more of a typo report.
In the Debug Logger doc page , app_trace_init() is supposed to return an int but in its function declaration it's said to return...
when I call ble_nus_send_string,I got the error, error code is 0x00003003, Then I find error define like below
#define BLE_ERROR_NO_TX_BUFFERS (NRF_ERROR_STK_BASE_NUM+0x003...
I tested BLE mesh example. I have 4 boards 1 nRf52832 and 3 nRF 52840
1 board as client(nRf52832)
1 board as Provisioner(nRF52840)
2 board as server(nRF52840)
i loaded...
Hello
I'm trying to use the secure bootloader from the SDK Examples. It worked all fine with downloading and the example package.
But if I try to make my own application...
I am trying to come up with a BLE solution for a Linux based audio project. The Linux target would function as a hardware appliance and as such would appear as a BLE peripheral...
Hello Community,
I have been trying to avoid asking this question here (it may be trivial) but I guess the answer will help other people as well.
In the ATT_MTU throughput...
I was on Instagram, and I won a green nordic 52 from Nordic. I got it, became frustrated because I didn't have a JTAG debugger, and flashed espruino onto it with nRF toolbox...
Hello,
I have a question regarding the correct way/good practice of programming with the use of SPI. I am using SDK 15.0.0.
I've written some code in a source file peripheral...
hi.........
i am using nrf52832 and segger 15.2
i am merging the two programs in order to send the data through ble to phone(uart app)
i am getting the error
undefined...
hi !
I have start to program the SPI example to communicate with the BMP280 from Bosch and i have seen good results so i'm tried to implement the code over ble_app_uart...
hi..........
i want to put my peripheral device in sleep mode ? how to do that?
i tried this one , its shows error
err_code= sd_power_system_off();
APP_ERROR_CHECK...
Dear Nordic Team,
Thanks for supporting.
Currently i am trying to work with multilink central in NUS_C example based on ble_app_multilink_central. The edited code was...
