Hi,
I was looking at the .map for my project and I noticed that pstorage.c was taking up a bunch of RAM (~600 bytes), which I thought was a lot, so I went into pstrorage_platform...
The document nRF51422_Evaluation_Kit_User_Guide_v2.0.pdf says:
Locate the Heart Rate demo project found in the folder
ARM\Device\Nordic\nrf51422\Board\pca10003\s310\ble_app_hrs...
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Hi All
I am doing a BLE based project using nRF51822.Where i need to handle the message [with UUID] by using ble_gatts_char_handles_t.
so, can any one please share information...
I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples.
I've modified them to run on the PCA10001...
Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
According to the Kconfig documentation, https://nrfconnect.github.io/vscode-nrf-connect/kconfig/install.html , the active board is displayed on the Status Bar when editing...
Running a Thingy:91 now for 4 weeks from batter with one message exchange per hour, it stopped working (NB-IoT mode).
The client (Thingy:91) uses "sendto" and that function...
Was using SDK 1.9.1 up till now, but I migrated to SDK 2.0.0 and I changed my overlay file to add the pin control stuff. I have a nrf5340 and use the app_ns board config....
According the data written to NVM, is there a difference between "%XFSSYNC" and "+CFUN=0" ?
Reading the documentation, I see mainly user configuration be written.
I may...
Hello,
I am trying to add SDCard management, over SPI bus, into my project with nRF5340. When I try to compile, the error is always the same. I am trying the code over the...
Hello,
I have a problem that looks a bit like
devzone.nordicsemi.com/.../nrf52840-custom-board-won-t-boot-without-debugger-reset
For me, to be more precise:
nRF52840...
I just upgraded my environment from nRF Connect SDK v1.9.1 to v2.1.0. This process raised one critical bug, as well as some very important questions:
My projects make very...
The setup : nrf 52840 , NCS 1.9.1 , The SAADC is configured in advanced mode with 1 single end channel and double buffered with size of 16 (32bytes). RTC is configured to...
Hi,
I am reposting this as the previous question might have been closed due to inactivity from my side and the issue isn't resolved yet.
To follow up please check this...
Hello,
In BLE-Mesh models, we have APIs like:
To send data to other devices on the Mesh.
Here I observed that the context "struct bt_mesh_msg_ctx *ctx" stores...
Hello,
I am trying the BLE llpm code and made some changes in the existing sample code in the data length to 8 bytes from 4 bytes.
When transmitting a data of 8 bytes...
Hello,
Could you tell me the reference of the Li-po connector on the nRF5340-DK development board?
Indeed I would like to connect a Li-po battery to power this board....
