I have already made code of 3 pwm channels using c[0],cc[1],cc[2],cc[3]. I want 4 PWM channels but I dont have more cc registers left so how can i code it. plz help me.
ALso...
Hello, I have purchased this kit on ebay. www.ebay.com/.../301182420397
Can somebody point me to where I can get documentation on this kit, it came in with mostly Chinese...
According to the nRF51 series reference manual.
10.1.2 Debug interface mode
Debug interface mode is initiated by clocking one clock cycle on SWDCLK with SWDIO=1. Due...
Hi,
I was looking at the .map for my project and I noticed that pstorage.c was taking up a bunch of RAM (~600 bytes), which I thought was a lot, so I went into pstrorage_platform...
The document nRF51422_Evaluation_Kit_User_Guide_v2.0.pdf says:
Locate the Heart Rate demo project found in the folder
ARM\Device\Nordic\nrf51422\Board\pca10003\s310\ble_app_hrs...
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Hi there,
I have an smart product that will use both BLE & 2.4G Radio. There are few question about framework.
1. I saw radio packet contains such as S0 S1 ADDRESS etc...
I have noticed that the function sd_rpc_open(...) of pc-ble-driver takes more than 1.5 seconds.
I have tried an example heart_rate_monitor which is supplied with pc-ble...
Hello,
I am using nRF52840 DK, and SDK version 17.1.0.
I want to dynamically control CLOCK source.
I tried to release( STOP ) HFCLK( XTAL ) source using nrf_drv_clock_hfclk_release...
Hi there
When the EVENTS_DEVMATCH is raised, this signals that the device address received in the radio data packet matches one of all enabled addresses in the BASE0/BASE1...
Hello,
we faced sometimes the issue that the reset reason Register RESETREAS is Zero at Startup. What does it tell me? So what happend in the Firmware that there is a reset...
I haven't been able to find any documentation or forum posts along the lines of the problem I'm having, so...
I'm trying to use an nRF52-DK with nRF Connect Desktop to connect...
Hi,
I'm using nRF52840 with NCS 1.8 on the existing ongoing development project.
Recently I implemented shell commands, to be used during testing procedure either via...
Hello
I have seen that using SDK 1.17 there is a possibility to set one channel that will be scan 37/38/39. I looked on SDK 2.2 documentation and I didn't seen this option...
Hi
We encountered speed issues with the download client library and CONFIG_DFU_TARGET. The problem can be reproduced using the download example. Without any changes I usually...
Hello,
Im working right now on a product which saves the update file (init + app packet) on its Flash in a specified memory section.
After "uploading" the file in the...
I have integrated MCUMGR to perform FOTA and it does successfully perform the updates where both slot0 and slot1 locations are from internal flash. As the code size is getting...
Hello !
I bought a new nRF51DK board and need to read its RAM data. I used nRF connect to erase it. The data read by nRF connect shows 262144 bytes and I don't know the...
Reproduce issue:
Windows 10 21H2
Set global git option gpg.format to ssh
git config --global gpg.format ssh
Install nRF Connect SDK v2.0.2 with Toolchain...
