I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hello,
I am trying to ecrypt some data in order to send some data encrypted in the MINOR and MAJOR adverts of the device.
I used this code to ecrypt the data ( this is...
Hi there,
We have a mesh network which runs now for quite some time on our own hardware. We are using heartbeat messages to collect RSSI values between nodes in the network...
Hi Dev team,
I was looking through the documentation of PMIC from the Thingy91 User Guide and I saw that the PMIC in Thingy91 can be used for battery charging (" The PMIC...
Hi,
I do not get any neighboring cells reported using this command. Is one particular state required to receive information regarding neighboring cells?
-Marius
Hello world :-)
I am writing I2C temperature sensor driver over `i2c0` working in `twi` mode in Zephyr with my custom `dts` board configuration and this pops up on the console...
The current platform of the AOA contains 12 antennas multiplexed into one 52833 module
The distance between each antenna is small, hence the angle delta that can be detected...
Hi Nordic Support Team,
It can connect and read the Service UUID and Characteristics UUID, but when I am trying to do the DFU update on the iOS (iOS 14.5) but it will disconnect...
Hi,
I am developing the system where I am sending the data of three sensors to the server using MQTT. For the above development, I used two microcontrollers one to collect...
Hi Nordic Team,
I would like to share with you a minor challenge that we are facing to use the nRF52840 dongle with a Zigbee Mesh network and issuing a serial communication...
Hello,
Does anybody know where I'll be able to find an EAGLE library for the nRF52840 CKAA chip (the WLCSP-93 package)? I've looked around and all other dev boards that...
Hi,
I'm having doubts about whether to use NUS or OTS to transfer 500 bytes of data from the peripheral device to the smartphone. Regarding OTS, I've tried using the ble_ots_central...
Hello.
I am developing using nrf52832 (S132 v7.0.1, SDK v16.0.0) as a central and Android device (Bluetooth 4.2) as an advertisement.
During development, I was wondering...
