I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
I'm using the nRF51822 eval kit
I have installed MCP but after starting I get pop-up: Master Control Panel has stopped working
In nRFgo Studio / Device manager pane...
the proximity example is running ok. but when I modify the length of the alert_level I have the following error on the server side that I am not understanding.
476;16:12...
Hi all,
I'm working with the nrf51422 and the nrf51822 and I was wondering what the current status of the over the air DFU system is.
I'm using SDK 6.0 and I managed...
nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hi All.
We are trying to do DFU on a device using s132_nrf52_5.0.0_softdevice.hex.
The DFU interrupts first time when it is around 15-20% complete.
When the DFU is attempted...
Hi!
I am using nrf52840,sdk 14.2,Keil IDE
I am using bmp180 and mpu6050 sensors.
In proximity code,I have integrated both sensors separately,It works fine.
But while...
Hi all
i'm new in both this site and nrf52
i have a question
Is there ADC CONFIG register in nrf52? i can't find ADC_CONFIG in nrf52
NRF_ADC->CONFIG = (ADC_CONFIG_EXTREFSEL_None...
I have an application where I am sending a fixed packet length of 32 bytes to data pipe 1.
I have set the data width to 32,
I have auto acknowledge enabled on P1.
I...
Hi,
I designed a nRF52832_xxAA board, I can't find the bluetooth name in iphone - settings - Bluetooth - Devices, but I can read/write and notify in myself mobile app and...
Hello,
I am using sdk version 15.2.0 and nrf52840. In the application NAND flash TC58CYG2S0HRAIG is used. We are using flash to store values which we receive from the USB...
1.I want to know whether there is any existing network in the same channel .And get the existing network's information like PAN ID.
Any APIs to do this?
2.How to set...
Hi,
I'm trying to run a display using SPI, and I've run into some troubles. I've attached my code below:
My issue is that the program never gets past the while loop...
Hi,
I am getting the GATT ERROR during init packet stage during firmware upgrade. I am using SDK 14.2 and nRFConnect application on Samsusng Galaxt S8. It looks like I am...
Dear Team
We have selected nRF52840 in our design.
I am layout designeer.
Please send refenrence layout section for nRF52840 to me.
I want study rhe layout design...
Hi,
I am currently developing Bluetooth Mesh for our battery powered products which needs to be updated on demand.
I am running the Mesh light switch examples on the...
Hi,
I'm completely new to the Bluetooth trying to understand a thing or two.
Bluetooth 5 comes with Mesh support and NRF52 supports it with Mesh SDK.
Now my Questions...
Stack - nRF52 DK, SDK 15.0.0, Segger Embedded Studio, Windows. Using code examples described below.
So my high level goal is to read data from registers in an I2C sensor...
