hi support team,
customer is testing our nrf93M1 module, and find out, when device enters system mode after sleep, there will be a lot of URL sending to UART as below: ...
I'm not sure if I can share the files here, but you can email me at kc6ete at gmail if you want a copy It's a four color print designed for the Snapmaker U1 though it can...
Dear Team,
I have been running two nRF54LM20-DK as Initiator and Reflector for Bluetooth Channel Sounding.
I adjusted the ranging algorithm RAS_Initiator to print Local...
Hi,
I'm trying to find out how people automate current measurements with the PPK2 beyond doing it by hand in the Power Profiler app.
From the threads here it looks like...
During the setup process for nRF Connect SDK v2.4.0, an error occurred preventing the SDK from installing correctly.
The environment details are as follows:
* macOS...
Hello, I am trying to make a sinusoidal by using the PWM module with an interrupt handler.
The thing is, the signal looked perfect from the development kit. However, when...
Hi there. I've designed a PCB around the NRF52833-QDAA, mostly following the variation 2 sample layout. Upon assembling my board, I was able to flash it exactly one time using...
I've just built the slm_lte_modem application using SDK 2.2.0. I've also programmed modem firmware 1.3.4 into the device. I have access t the AT command set and most of them...
Hi Sirs,
in nRF5340, is it doable for to adjust the power index of different channels of BLE_1M or 2M, in terms of SW code (if there is then where? or NVRAM like setting...
Hi,
after the manual installation the Quick Setup of nRF Connect for VS Code says
that GNUARMEMB_TOOLCHAIN_PATH and ZEPHYR_TOOLCHAIN_VARIANT environment variables are...
Hi,
I'm using nrf9160dk and i want to run HTTPS_CLIENT example to send some ping.
when i run the HTTPS_CLIENT I'm getting error:- " getaddrinfo() failed, err 0 "
i haven...
This question is all about massaging CMake I guess, but I cannot get any clear answers from the CMake documentation. Here is my problem:
I have a NCS based project that...
Hello,
I'm using the nRF52832 product, nRF5_SDK_15.3.0_59ac345, and the android S21 mobile phone as a back-end system. I'm working on ble_app_bps, ble_app_gls, and ble_app_hrs...
Hello everyone, I'm using the secure_bootloader example to load the application into my device. I need to detect bootloader progress, can anyone tell me how? I would like...
The documentation states that SB2 must be cut and SB1 soldered.
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fug_nrf52840_dongle%2FUG%2Fnrf52840_Dongle%2Fhw_power_ext_reg_source...
Hi Jørgen,
I have an issue when trying to link the libmodem.a library in the nrfxlib/nrf_modem directory. I'm using the following version of MDK-ARM: Tool Version Numbers...
Hello,
I m using nRF 52832 with SDK 15.0.0 .
In my current project want to use two UART at at time in same code .but from SDK not found settings regarding UART1 [ There...
Hi all,
I'm new to the whole kconfig system, and I can't seem to change the Asset Tracker to passive mode.
I've tried adding these lines to the prj.conf file:
CONFIG_DATA_DEVICE_MODE_PASSIVE...
