Our prototype is back. At first, I used NRF Connect to flash it, but the official PC software couldn't flash the firmware. I followed the wiring instructions: (1) connect...
We are developing an application based on the nRF9151 using NCS 3.1.1 and modem firmware mfw_nrf91x1_2.0.3 .
We would like to use Proprietary PSM to control the modem's...
Hello, The nRF9151 hardware design guidelines (power sequence) require VDD_GPIO to be applied at least 6 ms after VDD and ENABLE, after the hardware boot. In our design a...
I'm not sure if I can share the files here, but you can email me at kc6ete at gmail if you want a copy It's a four color print designed for the Snapmaker U1 though it can...
Dear Team,
I have been running two nRF54LM20-DK as Initiator and Reflector for Bluetooth Channel Sounding.
I adjusted the ranging algorithm RAS_Initiator to print Local...
Writing a BLE firmware can now be done with a few lines of code. The code example bellow is all you need to write for a non-connectable BLE firmware that advertise a counter value every second in the…
Hello
I wrote a tutorial on using the nrF52 Development Kit with Keil MDK.
www.keil.com/appnotes/docs/apnt_308.asp
This document features essential debugging capabilities of the nrF52 series.
ETM Instruction…
1.Profile
During connection procedure of BLE, there are three packages: SCAN_REQ, SCAN_RSP 和 CONNECT_REQ。
SCAN_REQ: Scan request, issued by MASTER DEVICE, send to SLAVE DEVICE,sent by the Link Layer…
1.Profile
MTU: ATT Maximum Transmission Unit (MTU) is the maximum length of an ATT packet. The ATT MTU is defined by the L2CAP and can be anywhere between 23 and infinity. The implementation of the Bluetooth…
Today I tried to find the better ways to debug program on nRF52840 PDK from CLI on linux.
The ways that I tried
[Failed] openocd (both stlink and jlink) & gdb
[Succeeded] JLink & JLinkGDBServer &…
This article baed on "pca10040", nRF52832
example code path "examples/ble_peripheral/ble_app_uart"
IMPORTANT!!!!
board config file of this example located in "components/boards/pca10040.h"
and uart…