Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
hw-flow-control fails on nRF9160DK VCOM1 if I add it to device tree, even though the schematic shows the signals all connected to the nRF52840 0

I have tried several code samples: nrf/samples/bluetooth/peripheral_uart and nrf/samples/openthread/cli. If I set hw-flow-control in zephyr/boards/nordic/nrf9160dk/nrf9160dk_nrf52840...
32 views

0 replies

Started 1 day ago
by Burt
Not Answered
Self-Protecting device images 0

We recently encountered an issue with incompatible image partitions being pushed to in-field devices causing soft bricking. refer to this ticket for more information Problem...
42 views

0 replies

Started 1 day ago
by Andrew Sanders
Not Answered
nRFL05 PDM Clock Formula Wrong ? 0

Page 399 of nRF54L15/nRF54L10/nRF54L05 Datasheet v1.0 shows: CLK = PCLK32M/(2*PRESCALER) but this formula does not match the values in the examples in Table 46. I CAN...
30 views

0 replies

Started 1 day ago
by Chris Nielsen
Not Answered
External Flash related issue 0

Hello Nordic Team, I am currently working with the nRF52832 on a custom board using nRF Connect SDK v2.9.0. I am implementing OTA DFU using Sysbuild and MCUboot with an...
35 views

0 replies

Started 1 day ago
by Embel_Tech
Not Answered
External OTA related issue (SPI + External Flash + OTA) 0

Hi Team, I am working on OTA using an external Winbond flash IC (W25Q64) with the nRF52832 controller in NCS SDK version 2.9.2. I have completed all the required configurations...
42 views

0 replies

Started 1 day ago
by Rohit15

Recent in the DevZone Blog

Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015
nRF51 Qt GCC Example

Jacob Portukalian

Hi Everyone! At Sky Wave Design, we recently switched all of our Nordic development over to using GCC and using Qt Creator as the IDE. We have released our example project on github for those of you…
- 31 Jul 2015