Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Energy consumption in NTN mode vs LTE-M 0

Hi Have you done any benchmarking to estimate the difference in power consumption when comparing the nRF9151 in NTN mode vs LTE-M? In particular I am curious if NTN has...
21 views

0 replies

Started 3 hours ago
by ovrebekk
Not Answered
SUPL client license 0

I requested a SUPL client license as I want to evaluate the AGNSS feature, but it got declined for some reason. And when I try requesting another one, nothing happens. Does...
23 views

0 replies

Started 4 hours ago
by Pieter0
Not Answered
Can’t generate ncs-sbom with nRF Connect SDK v3.1.1 0

Hello. When I ran the NCS SBOM command using VS Code, the following error occurred, and the file could not be generated. I would appreciate it if you could tell me how...
31 views

0 replies

Started 9 hours ago
by Fumiya
Not Answered
nRF54L15 Channel Sounding chain—scheduling conflicts with simultaneous initiator and reflector roles 0

I am using nRF Connect SDK 3.4.1 on three nRF54L15 devices: A ───────── B ───────── C A–B: A central / CS initiator B peripheral / CS reflector B–C: B central / CS initiator...
50 views

0 replies

Started 17 hours ago
by unknown0123456
Not Answered
Title: nRF54LM20 DK debug-out (P13) reset line holds an external nRF52840 target in reset after a pin reset or CTRL-AP hard reset 0

Setup - Programmer: nRF54LM20 DK (PCA10184), debug out header P13 to an external board over a 10-pin ribbon under 10 cm, SWD0_SELECT grounded on the target side. The DK...
51 views

0 replies

Started 22 hours ago
by dm1

Recent in the DevZone Blog

Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015
nRF51 Qt GCC Example

Jacob Portukalian

Hi Everyone! At Sky Wave Design, we recently switched all of our Nordic development over to using GCC and using Qt Creator as the IDE. We have released our example project on github for those of you…
- 31 Jul 2015
ROM and RAM Management

Øyvind Karlsen

Introduction Here are some tips and tricks to manage your application size. RAM and ROM usage The total RAM usage is: ZI-data + RW-data The total flash usage is: Code + RO-data + RW-data …
- 28 Jul 2015
Controlling an RGB LED with Nordic nRF51-DK

Mahesh Venkitachalam

Using PWM and Nordic UART Service on nRF51-DK (nRF51822/nRF52422) to control an RGB LED over BLE. http://electronut.in/nrf51-rgb-led-test/
- 25 Jul 2015