Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
GPIOTE port event and pin events enable issue simultaneously 0

hi all , how to enable GPIOTE PORT and IN[n] event simultaneously ?(not same pin) i enable the GPIOTE to trigger interrupt event. one for the keyboard which need multiple...
- gpiote
- nrf51822
1774 views

0 replies

Started over 10 years ago
by steven
Not Answered
Cycle speed and cadence sensor data , even after stopping the cycle ? 0

Hi All, I am using nRF51422 with softdevice s310. And implementing Cycle speed and cadence receiver. most of the data processing is fine but i am facing one problem. ...
- nrf51422
- ant
733 views

0 replies

Started over 10 years ago
by Robin
Not Answered

Write and read back the FSR register failed 0

Hello Nordic Team, I have a problem with programming the nRF24LE1 chip. I am developing a small system, which consists of a uC STM32F4xx and a nRF24LE1 Radio Module. The...

925 views

0 replies

Started over 10 years ago
by MasterAlexei
Not Answered
SDK 6.0.0 OTA DFU iOS compatibility 0

Hi, I'd like to learn about the app compatibility for the new OTA DFU that ships with the new SDK 6.0.0 and S110 7.0.0. I am using a nRF51822 board and I've observed that...
- s110
- bootloader
- jlink
- keil
- dfu
- nrf51822
1361 views

0 replies

Started over 10 years ago
by Florin
Not Answered
GATT database for a server 0

I'm curious to know if there is a tool that allows easy design of a GATT server DB that is portable across dev platforms (the nrf518 EK, my Android/iOS dev environment etc...
- gatt nrf51822
- bluetooth low energy
1545 views

0 replies

Started over 10 years ago
by kb

Recent in Nordic blog

Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018