Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered

Is Beacon battery condition advertised? 0

Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?

693 views

0 replies

Started over 10 years ago
by nmdjapan
Not Answered
How message can be handled? 0

Hi All I am doing a BLE based project using nRF51822.Where i need to handle the message [with UUID] by using ble_gatts_char_handles_t. so, can any one please share information...
516 views

0 replies

Started over 10 years ago
by renu
Not Answered

Central App stuck after service discovery 0

I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples. I've modified them to run on the PCA10001...

764 views

0 replies

Started over 10 years ago
by Erik Sanchez
Not Answered

nRF51822 RX device can't receive packet from nRF24L01P TX device 0

Hi All, I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device. nRF24L01P TX device Register settings are as follows; Reg.EN_AA=0x00...

660 views

0 replies

Started over 10 years ago
by Mike
Not Answered
S130 programming for the nRF51822 mkit with gcc on a raspberry pi 0

I am trying to develop for some nRF51822 mbed boards, and I would like to use the S130 SD to enable both central and peripheral behaviour. The machine I'm using for development...
1089 views

0 replies

Started over 10 years ago
by Jimi Cullen

Recent in Nordic blog

Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018
Testing Long Range (Coded PHY) with Nordic solution (It Simply Works)

Susheel Nuguru

**Project and hex files for testing this is attached in the end of this blog. Introduction There has been a lot of discussion/testing/confusion about testing the long range feature of Bluetooth Low Energy…
- 2 May 2018
Introducing experimental release of Programmer Application

Reidar Martin Svendsen

nRF Connect for desktop has proven its flexibility by being cross platform and ability to install and update applications based on users need. Motivation Our initial goal was to modernize and cover…
- 30 Apr 2018
New in nRF5 SDK v15: Strong Hardware-Based Security with Infineon OPTIGA Trust X

ChristianLesjak

Defining a business model and implementing a technical infrastructure are two major phases in building a successful product or IoT system. However, protecting the business model and your customer’s data…
- 9 Apr 2018