Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
S310 radio hardware 0

Hello, can the radio notification and radio disable APIs be used to use the radio hardware from the application layer? Background of my question is, that I have an application...
632 views

0 replies

Started over 10 years ago
by Torsten Robitzki
Not Answered
Retrieve the peripheral name advertised when connection has been done 0

Hi, I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral. When connection is done, the...
- 120 s110 nrf51822
805 views

0 replies

Started over 10 years ago
by Sébastien Despont
Not Answered

AES ENCRYPTATION with sd_ecb_block_encrypt in nRF51822 BLUETOOTH SMART BEACON KIT 0

Hello, I am trying to ecrypt some data in order to send some data encrypted in the MINOR and MAJOR adverts of the device. I used this code to ecrypt the data ( this is...

1325 views

0 replies

Started over 10 years ago
by Ivan Gómez
Not Answered
nRF UART App error 0

Hi, i use anRF51822 with soft device 7. I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5. Both devices connected...
- s110
- bluetooth low energy
- uart
- keil
- nrf51822
- nordic
1727 views

0 replies

Started over 10 years ago
by max
Not Answered
nRFgo Studio will not launch after upgrading to 1.17.0 0

Hello, I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
- nrf51822 nrfgo
953 views

0 replies

Started over 10 years ago
by Archie

Recent in Nordic blog

Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018
Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018